Deltaking
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: son compatibles con la Ender 3 pro?
gevraagd door BG551652501 op 2021-03-03 22:18:12
Deltaking yes
Nuttig (0)
Q: what size filament dose this printer take out of the box?
gevraagd door Supertrowel1 op 2020-10-04 03:59:39
Deltaking 1.75mm
Nuttig (0)Q: È possibile aggiungere il sensore di filamento? Is it possible to add the filament sensor?
gevraagd door BG533217492 op 2021-02-25 13:29:20
Deltaking Thedevice has extra ports so If you know our firmware well you could add one but would most likely void the warranty as it is a modification you will need to apply to the device
Nuttig (0)Q: funziona benen con abs ho crea problemi di adesione ?
gevraagd door mask66 op 2018-11-06 11:12:05
Deltaking Itworks well with ABS but using a device like this for ABS it would be best printing during a warm day without the enclosure. If you want to print ABS well an enclosure would be the best bet
Nuttig (0)Q: What is the magnet maximum temperature? Is it neodymium or ferrite based magnet? Thanks
gevraagd door TheJ0y op 2018-10-24 08:30:34
Deltaking I found that pushing anywhere above 90 deg on the bed temp the magnet separates from the build track after a while. If you plan to continually print with the heated bed above this temp i would recommend looking at an alternative. (no details on what type of magnet it is but does not seem to lose its charge)
Nuttig (1)
Q: vale para ARTILLERY GENIUS?
gevraagd door titemi op 2020-10-26 18:03:35
Deltaking It will work on any FDM printer with a bed size of 235mm x 235mm or smaller (as long as it doesn't intercept moving parts)
Nuttig (0)Q: Does it work benen with abs I create adhesion problems?
gevraagd door mask66 op 2018-11-08 11:13:20
Deltaking Itworks well with ABS but when you start to exceed 90 deg on the bed the build track starts to separate from the magnetic bottom
Nuttig (0)
Deltaking itcould but your print area would be much less pending which CR10s version
Nuttig (0)