Alle berichten

Q: which flight controller will fit this thanks

gevraagd door Paul Sheriff op 2018-11-21 06:44:52

michiakj crazybee

2022-03-08 06:04:24 Nuttig (0)
Verzenden
antwoorden (2)

Q: Have you got 6s version of these ?

gevraagd door Sheriff_fpv op 2019-10-20 10:28:13

Piyushkayta no

2022-02-19 09:41:57 Nuttig (0)
Verzenden
antwoorden (3)

Q: can a go pro hero 5 fit in this thanks

gevraagd door Paul Sheriff op 2018-07-13 04:30:22

HazzahFPV O think the hero 5 will only fit if you remove the little lip at the front. However, if you do that it will not sit as securely anymore. I woul recommend browsing thingiverse and getting someone to print a mount exactly how you need it. Will probably turn out cheaper.

2022-01-23 10:15:38 Nuttig (0)
Verzenden
antwoorden (2)

Q: does it have built In OSD

gevraagd door Paul Sheriff op 2018-08-01 07:26:54

BG551339942 ótimo

2021-12-18 03:49:30 Nuttig (0)
Verzenden
antwoorden (2)

Q: does this have a built in OSD

gevraagd door Paul Sheriff op 2018-07-25 02:51:48

alemir85 no. its power destribution board

2021-11-22 01:05:38 Nuttig (0)
Verzenden
antwoorden (4)

Q: where can you connect your osd to which solder pad not sure on this?

gevraagd door Paul Sheriff op 2018-08-01 01:55:48

Timship1 Look up a wiring diagram for this fc, all pins are covered on them.

2021-11-10 06:29:44 Nuttig (0)
Verzenden
antwoorden (2)

Q: when is this back in stock ?

gevraagd door Paul Sheriff op 2018-09-11 02:16:54

teo2laspina in stock soon or there are other similar products

2021-10-15 01:55:30 Nuttig (0)
Verzenden
antwoorden (2)

Q: would this fit a Lisam LS-*****mm Carbon Fiber frame thanks

gevraagd door Paul Sheriff op 2018-07-13 04:35:36

Jonathan yes it should, standard size. otherwise with double sided rubber

2021-10-09 12:22:49 Nuttig (0)
Verzenden
antwoorden (1)

Q: what is the VCC pad used for ?

gevraagd door Paul Sheriff op 2018-11-17 12:12:30

wavesummit VCC stands for Voltage Common Collector. It's the full voltage of the lipo, some flight controllers need the full voltage to display on the OSD. Alternatively you could solder to the same pad as the battery but this makes it easier.

2019-04-02 07:14:18 Nuttig (1)
Verzenden
antwoorden (4)

Q: have you got crossfire version

gevraagd door Sheriff_fpv op 2020-07-21 04:10:39

Saponaceous Nope . You can connect the TBS receiver by yourself.

2020-08-05 04:07:31 Nuttig (0)
Verzenden
antwoorden (1)

Q: how big is the pub board for leds

gevraagd door Sheriff_fpv op 2019-10-20 03:23:02

HOMIEEE 32mm Length x 5mm Width

2019-10-31 03:52:57 Nuttig (0)
Verzenden
antwoorden (1)

Q: what are the measurments 150cm what ?????? hight ,wide and long ?????

gevraagd door Sheriff_fpv op 2019-09-08 01:50:48

Uli1254 150 * 150 * 120CM

2019-10-24 11:51:18 Nuttig (0)
Verzenden
antwoorden (1)