Wanneer u een website bezoekt, kan deze informatie in uw browser opslaan of ophalen, meestal in de vorm van cookies. Deze informatie kan over u, uw voorkeuren of uw apparaat gaan en wordt meestal gebruikt om de site te laten werken zoals u verwacht. De informatie identificeert u meestal niet rechtstreeks, maar kan u een meer gepersonaliseerde webervaring bieden.
Omdat we uw recht op privacy respecteren, kunt u ervoor kiezen om bepaalde soorten cookies niet toe te staan. Het blokkeren van sommige soorten cookies kan echter van invloed zijn op uw ervaring van de site en de diensten die we kunnen aanbieden.
U staat: toe
Strikt noodzakelijke cookies (verplicht)
Deze cookies zijn noodzakelijk zodat u op onze website kunt surfen en de fundamentele diensten ervan kunt gebruiken, en hiervoor is uw toestemming niet vereist. Met deze cookies kunnen wij u de essentiële functies van de website aanbieden (accounttoegang, gebruikte taal, gespeelde bestelling, betaling etc), en kan ook worden gebruikt voor identiteitsverificatie en beveiliging. Als u deze uitschakelt, kunnen we niet aan uw basisverzoek voldoen.
Deze cookies verzamelen anonieme informatie over uw online bedieningsgedrag die ons helpen de websiteconstructie te verbeteren. Als u deze cookies weigert, is het mogelijk dat u bepaalde functies van onze websites en diensten niet kunt gebruiken.
Deze cookies stellen ons in staat om de keuzes die je hebt gemaakt over je voorkeuren te onthouden, zoals welke taal je voorkeur heeft. Als u deze cookies weigert, kunt u het gevoel hebben dat de efficiëntie van het surfen op het web is afgenomen.
Deze cookies voeren gepersonaliseerde activiteiten uit om reclame te maken voor producten en diensten waarin u geïnteresseerd bent. Als u deze cookies weigert, krijgt u nog steeds advertenties te zien die niet zo relevant zijn voor uw interesse of vraag.
MikeRoberts Sorrythese do not work direct with a Raspberry Pi. I made the comment above after driving a PT2314 on a JBL on-time direct with no problems. The problem with the modules relates to their ability to pull the data line low to give the ACK I2C notification. The chips on the two modules I bought had a weak pull down (to only around 1/3V) and hence the Pi did not see this and terminated the transmission. The modules did work with an Arduino Uno that has a lower pull down current (around 0.5ma) compared to the Pi that takes 2ma. So in broad terms these should work with 10k pullup resistors but are unlikely to work with pull-up resistors of 3k3 or less. I normally use 3k3. An I2C voltage level converter should provide adequate pull-down to drive the Pi and may have a low enough pull-down current for the PT2314 modules. Also these modules have 1k resistors in series with the data and clock inputs. These should not be there and make the situation worse. Hence best to short these out (R11 and R12). Mike