Alle berichten

Coops There is no "calibration" required. Every time you switch it on, you first must close the jaws... only if it does not show "zero", then you press the Zero" button. Normally the previous Zero setting is retained and will be OK, so no Zero'ing will be needed. However if it doesn't show zero then it's easy to press the button. The other reason to use this button is to make partial measurements - for example to check the *difference* between two measurements by pressing Zero after you take the first dimension, then measuring the second (display will show + or - difference).

2018-12-14 08:10:15 Nuttig (0)
Verzenden
antwoorden (1)

BG124644135 This device runs from the mains electricity supply and does not require any batteries.

2023-01-14 04:47:25 Nuttig (0)
Verzenden
antwoorden (1)

mrbufferng - Replaceable lens design: 6 replaceable lenses, 1.5X20x2.5X3.5X4.0X4.5X; lenses are made of acrylic resin, and the surface hardness of the lens can reach 5H level, which is more wearable and durable.

2021-10-17 03:20:46 Nuttig (0)
Verzenden
antwoorden (1)

milodecourcy with the original miter stop the stop arm folds over the pointer that aligns with the ruler scale covering half of the pointer. the new left miter stop's, stop arm folds in the opposite direction away from the pointer this makes viewing the pointer much easier as the ruler is closer to the operator and the view is unobstructed

2021-08-25 08:59:51 Nuttig (0)
Verzenden
antwoorden (2)

Q: is USB-A side also reversible ?

gevraagd door alaincoste op 2018-10-26 04:22:13

JoGeo Only the micro connector is reversible

2021-07-23 10:50:08 Nuttig (0)
Verzenden
antwoorden (2)

Q: for which size of bed ? 1 or 2 persons ?

gevraagd door alaincoste op 2020-10-05 04:15:59

Xuthus If you have questions, you can send an email for customer service help

2020-11-02 04:49:24 Nuttig (0)
Verzenden
antwoorden (1)