Alle berichten

The seller Hello, you can take a look at the third picture in our link, which shows the effect of 4D 16Line.

2024-04-08 03:08:48 Nuttig (0)
Verzenden
antwoorden (1)

Q: what size is it?

gevraagd door PoppyAnn op 2024-01-17 02:32:47

Whiskers 198 mm x 198 mm or in English or American 8 inches by 8 inches. it shows that in the advert.

2024-01-22 06:47:51 Nuttig (0)
Verzenden
antwoorden (1)

Q: Any chance of a metric version? no one uses imperial anymore!

gevraagd door phlppip op 2023-04-04 07:54:41

PoppyAnn all of the USA use imperial measurements

2024-01-17 02:46:34 Nuttig (2)
Verzenden
antwoorden (6)

Q: is it true rms?

gevraagd door leogaldino op 2018-10-09 06:36:45

PoppyAnn if it is a real oscilloscope then it should be true rms or the waveform will be clipped at the top and bottom

2024-01-17 02:21:56 Nuttig (0)
Verzenden
antwoorden (7)

Q: Where can I get a user's manual in English?

gevraagd door BG450911483 op 2023-03-22 01:06:58

PoppyAnn Not the best answer "you can get it from the internet" may be putting where on the Internet would be better or do you expect someone to start at one end and look at every page?

2024-01-13 01:54:08 Nuttig (0)
Verzenden
antwoorden (2)

Q: how long inveter can run 380w fridge

gevraagd door BG465400755 op 2022-09-01 10:49:11

PoppyAnn that will depend on what size battery you have it connected to, 380w will draw just under .6 amp with most inverters having around 50% conversion rate it would be drawing around 1.2 amps from your battery usually it is recomended not to draw your battery lower than 50% so if you have a 120 amp hour battery you can use 60 amp hour you should be able to run it for around 50 hours before it needs charging, hope this helps

2023-03-05 02:52:24 Nuttig (0)
Verzenden
antwoorden (1)

PoppyAnn I purchased 2 of these and neither worked from day 1

2023-03-04 12:25:05 Nuttig (4)
Verzenden
antwoorden (10)

Q: Bonjour, quel est le niveau du bruit en db, merci

gevraagd door didier op 2022-10-12 02:51:56

PoppyAnn it makes more noise when first starting but once it warms up a bit it drops down I fitted one to my caravan inside the gas locker which is only 3 mm to 4 mm of fibreglass from the main seating area and once it warms up you can only hear the fan blowing the hot air inside I tried it at home first and stood at the side of it you can hear anyone else talking to you, it is well worth fitting the air in and out silencers as the one on the exhaust cuts out most of the noise, also make sure that the exhaust is as far away from the air intake to prevent it from pulling exhaust gas into the air intake, always make sure the air intake is upwind of the exhaust.

2023-02-12 12:10:18 Nuttig (2)
Verzenden
antwoorden (2)

Q: Can I change the 4inch tyres to 3inch tyres on this bike

gevraagd door booboo op 2022-08-14 01:42:35

PoppyAnn I would expect so but by fitting a 3 inch tyre on to a 4 inch rim would cause the tyre to stretch across the wheel rim which would reduce the distance from the wheel rim to the road which would reduce the suspension that the tyre gives when it goes over bumps, or were you going to change the wheel to a 3 inch one?

2022-08-22 03:41:37 Nuttig (3)
Verzenden
antwoorden (2)

Q: does it require soldering?

gevraagd door BG251414821 op 2021-07-10 11:26:25

PoppyAnn only if you use a different type of plug for the battery I only use xt60 plugs on all of my models along with all of my batteries, as soon as I get anything with a different connector I just chop it off and replace it with the new xt 60 connectors they have an extra piece that you push on the wires, once you have soldered the cables you push it down and it covers the joint so you don't even need shrink fit tubing to insulate the connection as it covers it up and looks much better.

2022-08-22 03:18:22 Nuttig (0)
Verzenden
antwoorden (9)

Q: ciao incide su pelle e tessuti???

gevraagd door BG210018573 op 2021-11-25 11:51:03

PoppyAnn if you put them under the laser beam then yes it will affect skin and fabrics, but if you mean in the area close to the machine when operating then no it will not affect skin or fabric just make sure that you don't look directly at the beam unless wearing protective glasses.

2022-08-13 01:21:15 Nuttig (0)
Verzenden
antwoorden (3)