Alle berichten

HamsterHybrid Wennthe module is in "SET" mode, you can't send and receive commands, because the module awaits your settings via Serial. There is no need to constantly have the SET pin grounded, usually you set the module's settings once and that's it.

2021-10-29 05:56:59 Nuttig (0)
Verzenden
antwoorden (2)

Q: esse dispositivo é para que função, serve para o que?

gevraagd door sidnei op 2018-03-27 10:16:20

HamsterHybrid para a comunica o sem fios entre dois microcomputadores como o Arduino. possvel enviar dados entre 2 ou mais desses.

2021-10-29 05:54:25 Nuttig (0)
Verzenden
antwoorden (2)

Q: what connection type is ant1? u.fl, ipex?

gevraagd door tswmartin op 2019-02-01 11:21:05

HamsterHybrid Youcan solder the spring antenna to the board (or just a wire) or plug an external antenna into the IPEX port.

2021-10-29 05:53:08 Nuttig (0)
Verzenden
antwoorden (5)