Grandpa
mijn inhoud
Alle berichten
Beoordelingen
Reacties
antwoorden
vragen

Alle berichten

Grandpa 25/08/2022
I was a bit unhappy at first as I was not able to download the manual and my unit arrived with a cracked case. I began to investigate it and repair it. The instructions available on the sales page provided enough information to set the unit up and running some tests. The unit works better than I had expected. I was able to determine the frequencies used. Low = 62 Hz Med = 234 Hz Med 2 = 2 kHz and High = 14.5 kHz. The red knob selects one of 4 different internal resistances. The A/B push button turns on and off the dual channel mode so that you can easily compare one circuit board position to another. The Blue knob adjusts the position of the "B" Channel image on the scope screen. I added a power switch to the unit so that it could be left plugged in when I wanted to. I also added some English Labels and non-slip feet for the back so that it doesn't slide around on the bench. The only item I have not been able to identify is a Blue Jack on the front that is labeled "G" on the front and "T" on the internal board. If anyone has figured what the "G" Jack is please let me know. I wrote a complaint to Banggood about the inability to down load the Manual and about a week later they sent me the pdf file. Unfortunately it did not identify the "G" jack. Over All I am very pleased with the unit and the way it functions. I would recommend it to anyone who has a curiosity about curve tracers and a scope capable of X-Y operation.
Dual-channel VI Curve Tester, waarbij 2 golfvormen tegelijkertijd worden weergegeven voor gemakkelijke vergelijking
US$34.99 US$45.99
4
aanbevelingen
Reacties (2)
Grandpa 01/07/2022
I was very satisfied with these batteries. Unlike many brands the Nominal rating of 3000 mAhr was accurate. When I ran a power test I got a reading of 2920 mAhr. The batteries also weigh a little more than many of the batteries that are being sold. The batteries from this order were about 46 gm. I felt it was a very good buy and I will buy more in the near future.
4 stuks Astrolux® C1830 3000mAh 3.7V 18650 Onbeschermde Li-ion Batterij Oplaadbare Lithium Power Cell 9,6A Hoogwaardig voor Nitecore Lumintop Fenix Olight Zaklampen RC Speelgoed
US$27.99 US$29.99
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
3 stuks LM393 3144 Hall-sensor Hall-schakelaar Hall-sensormodule voor Smart Car Geekcreit voor Arduino - producten die werken met officiële Arduino-boards
US$5.99 US$7.99
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
Elektronische dobbelstenen kit met omgekeerde verbinding bescherming LED dobbelstenen DIY elektronische onderdelen
US$6.99 US$8.99
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
DIY NE555 Ding Dong Bell Deurbel Module Kit DIY Muziek DIY Elektronische Productie Trainingskit
US$2.49 US$2.99
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
Infrarood parkeersensor kit Infrarood snelheid achteruitrijdingsherinnering Elektronische printplaat productie DIY kit
US$7.99 US$9.99
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
If you have purchased this kit to test or improve your soldering skills do not be too hard on yourself. The traces on the circuit board are very fragile. I have years and thousands of hours of soldering experience and I had to repair 4 traces that broke while the unit was being assembled. The slightest torque on any of the components or LEDs causes the trace to lift from the board and break. Use a continuity meter to test your traces if the unit doesn't work and then use clipped leads to jumper across the breaks in the traces. You can't beat the price so forgive yourself on this one if it does't work right out of the gate. Also be aware that CCW on the trimmer increases sensitivity and CW decreases the sensitivity.
LM3915 10-segment Audio Level Indicator Kit Elektronisch Solderen Trainingsexperiment DIY Onderdelen
US$2.99 US$4.49
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
3 Delen Elektronische Dobbelspel Kit met Omgekeerde Verbindingsbescherming LED Dobbeltje DIY Elektronische Onderdelen
US$6.25 US$7.50
0
aanbevelingen
Reacties (0)
Grandpa 29/07/2020
OK
DIY Touch Vibratie Alarm Kit Elektronische Training Onderwijs
US$2.99 US$3.99
0
aanbevelingen
Reacties (0)
Grandpa 07/02/2020
I am quite pleased with this power supply control board except for one problem. The circuit is designed to use (3) TL081 Op Amps which have an Offset circuit built in. The Offset is necessary in the U2 position (lower right hand corner above the blue trimmer) if you want to bring your voltage to zero volts when the voltage control is all the way down. Unfortunately the TL081 chips that are currently being supplied with the kit are not quality and they do not have the Offset circuitry built into the chip. If you want to be able to zero your voltage output when the voltage control is all the way down you will have to purchase a quality TL081 chip for this position. At the price they are selling these kits for this is a small problem and easily remedied. John
0-30V 2mA - 3A Verstelbare DC Geregelde Voeding Module DIY Kit
US$4.99 US$9.59
0
aanbevelingen
Reacties (0)
Grandpa 23/01/2019
I have ordered these M-Testers a couple times and I have generally had good luck with them. The plastic cases make them a lot more usable and attractive. This batch however had one unit that didn't work properly. Looks like the Atmel chip is defective but at the cost per unit it is no problem.. I will use it for spare parts. A second problem with each unit seemed more serious. The test socket contacts would not open all the way. After removing the sockets from the board and checking them out I found that they worked just fine once they were removed from the board. The source of the problem was that the sockets had been soldered to the board by the manufacturer while in the closed position. This holds the contacts to one side and when the socket is soldered the solder holds the pins towards the closed side and doesn't allow them to open. The solution if you are having this problem is to simply open the test socket and heat up the solder to each pin to allow the pin to come to its normal open position. John
Geekcreit® LCR-T4 Mega328 Transistor Tester Diode Triode Capacitance ESR Meter Met Shell
US$9.99 US$21.99
0
aanbevelingen
Reacties (1)
Grandpa 15/10/2018
These buttons are momentary, not latching! The information supplied is contradictory as it states both latching and momentary. They are also small like the typical small key switch with an LED under the button.
Voedingssymbool Vergrendelingsschakelaar LED-lichtdrukknop SPST
US$6.99 US$8.99
0
aanbevelingen
Reacties (0)
Grandpa 27/09/2018
This is a normally open momentary switch.
Wendao R13-507 125V 6A 16mm Geen slot Zelfherstellende schakelaar Drukknop UIT/AAN 10st
US$13.99 US$16.99
0
aanbevelingen
Reacties (0)
Grandpa 26/07/2018
I was a little surprised by how small the cutters were, only 3.75 inches from pointed tip to end of handle but they cut very well and were well machined. I was able to cut typical leads at the very tip of the jaws with no problems. The small size may even be an advantage. John
DANIU Mini Tang Handgereedschap Diagonale Zijkniptang Stripknijptang Elektrische Draad Kabelknippers
US$3.59 US$9.99
0
aanbevelingen
Reacties (0)

Grandpa Sorry I missed your question earlier. 24cm wide X 9 cm high X 26 cm deep with approx 4 kg.John

Grandpa 29/08/2017
This is a very versatile and useful basic power supply circuit. So far I have used it to build several dual bench power supplies and other specialized test equipment. Lots of fun.
0-30V 2mA - 3A Verstelbare DC Geregelde Voeding Module DIY Kit
US$4.99 US$9.59
7
Reacties (2)
Grandpa 11/04/2018
I think this is the nicest little meter I have ever owned. It has features and accuracy found on meters 10 to 20 times more expensive. It even has an EM field detector so you can tell when a conductor is hot with lethal voltage. The only problem I had is that one of the internal fuses had popped out of its clips during shipping so I had to open the case and put it back in place. John
BSIDE ADM66 True RMS Digitale multimeter Auto bereik TRMS Mini 6000 DMM Dual Slot Capaciteit Ohm Hz Temp NCV Diode Pocket Tester MUSTOOL MT66
US$20.13 US$24.16
0
aanbevelingen
Reacties (0)
Grandpa 21/03/2018
I bought 5 of these and they are working great. My 11 year old grandson built one the other day and it turned out good after we discovered he had switched one 8550 with an 8050. It is nice when a mistake like this doesn't cause anything to burn up. After putting things where they belonged it worked well. We mounted it on a 6 volt battery box with a power switch and he had a nice little project to show at school.
5 stuks elektronische dobbelstenen doos kit 5mm rode led interessante onderdelen NE555 cd4017 elektronische productie suite
US$13.99 US$16.99
0
aanbevelingen
Reacties (0)
Grandpa 21/03/2018
As noted by other reviewers the circuit doesn't work well as designed but I do not agree with them as to how to fix it. R-2 39K has the purpose of introducing hysteresis into the circuit, however it creates way too much and extreme temperature moves are necessary to make it work. Just changing R2 from 39K to 100K brings the hysteresis down to 4 degrees C. The LED should have a current limiting resistor and there is a problem with Q1 overheating if the transistor is turned on to saturation by the variable resistor. Keep the variable resistor away from the 0 ohms end of its travel. This circuit was a lot of fun since it didn't work and took some study and experiment to make it function. For the price I had a lot of fun.
Temperatuurregeling Geluidslicht Alarm Kit DC3-5V Elektronische Circuit DIY Training Suite
US$2.43
2
aanbevelingen
Reacties (1)

Jij bent de expert, kan je helpen?

We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!

Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.

Help anderen en wees gelukkiger!

  • Abonneren

Over badges

Badges zijn gerelateerd aan de community en gebruikers verdienen badges door kwaliteitsinhoud te creëren, missies te voltooien of door deel te nemen aan speciale activiteiten. Specifieke mensen hebben ook hun eigen exclusieve badge.
CEO badge

de ceo-badge is alleen in handen van de baas van Banggood.

Badges die je kunt verdienen, komen binnenkort
  • Oké

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • Oké

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe