simon
Q: does this come with sd card which contains cura and samples to test for the machine
gevraagd door BG361025229 op 2020-12-15 02:49:42
simon comes with sd card and Creality version of cura, I've downloaded cura but to be fair not much difference
2020-12-16 12:51:34 Nuttig (0)
simon I've got solar panels,what connector is on these
2020-09-27 07:11:03 Nuttig (0)Q: Sorry, from where do you get the audio signal? Thanks.
gevraagd door BG472544461 op 2020-07-08 07:23:23
simon Hi no audio signal on this board
2020-07-09 12:49:31 Nuttig (0)
simon sorry can not translate
2020-07-01 12:10:10 Nuttig (0)
Templewas For more information visit techexperience.net/go/drones
2020-06-23 03:38:48 Nuttig (0)Q: how do I mount a gopro hero 5 on this frame?
gevraagd door tonyclarkinengland op 2020-06-18 10:20:50
simon it comes with a mount but to be honest I've gone for a smaller runcam 5 (4k)same size as the gopro session, I tried a gopro but it seemed a little heavy.
2020-06-18 01:27:40 Nuttig (0)
simon yes 4
2020-03-22 08:46:58 Nuttig (0)
Xuthus You can describe your SD card problem to the customer service in detail.
2019-10-30 03:30:48 Nuttig (0)
Q: Ive purchased one pretty good,can you run more than one camera on the same account.
gevraagd door simon op 2019-09-09 01:38:08
ouxinke Yes, there are no restrictions
2019-09-10 01:45:57 Nuttig (0)
We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!
Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.
Help anderen en wees gelukkiger!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
BG203725422 Yes, you may need new stepper motor as Creality push fit extruder gears and you also need to adjust e-step values
2022-05-30 11:58:44 Nuttig (0)