Ronaldsneek
Q: Can you reset the minimum maximum or is it per day and does it reset itself?
gevraagd door Ronaldsneek op 2018-08-10 03:01:27
marcar They should work fine with at least 3 V, probably very dimm or no light at all at 2.4 V (specifications: Forward Voltage:3.05-3.65V (250mA))Powering it with AAA batteries will not last much due to demanded current. Apart from this, when batteries discharge a bit, you will be below 3 V.Maybe a 18650 LiPo battery with higher capacity is a better option.
2020-02-17 08:57:48 Nuttig (0)
Dario NONARRIVATO.QUANDO ARRIVERA'?
2019-06-29 04:48:28 Nuttig (0)
Q: can you show the bottom side?
gevraagd door Ronaldsneek op 2019-05-03 01:11:50
lmml Sir youcan aks them to take an photo of this product for you :https://www.banggood.com/Contact-Us_hi111
2019-05-08 06:51:45 Nuttig (0)
Ronaldsneek If temperature is reached unit turns the heater off, If temerature is below the programmed temperature it will turn the heater on again. It is not self modumating, that happens only if the thermostat and the heater are from the same brand.
2019-01-07 05:03:09 Nuttig (1)Q: In Dutch it says "muffler pipe" do you get the muffler or also the pipe? Thanks!
gevraagd door Ronaldsneek op 2019-01-01 09:33:53Q: Will 13 or 14,5 Volt break the pir? for car use the dynamo is 14,5 Volt when charging.
gevraagd door Ronaldsneek op 2018-12-26 02:03:58
Hist Working voltage: DC 2.7-12V，it can't exceed 12V
2018-12-31 12:20:23 Nuttig (0)Q: Is the switch for turning off the light of the Voltmeter or the USB plug? Or both?
gevraagd door Ronaldsneek op 2018-12-21 03:40:25
Happypear both
2019-01-04 07:13:00 Nuttig (0)Q: Is it possible to switch the fan on and off with this product?
gevraagd door Ronaldsneek op 2018-08-25 06:38:18
Ogive you can try that
2018-08-31 04:59:37 Nuttig (0)
Lamella 9*6*4cm
2018-08-31 04:36:34 Nuttig (0)
Ronaldsneek Thank you very much.
2018-08-16 05:15:30 Nuttig (0)
Ronaldsneek Do you have it direct to a solar panel or via a solar panel controller?
We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!
Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.
Help anderen en wees gelukkiger!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
Franson Pressing and holding the C/F key will reset the high/low readings. Else it will reset automatically every 24 hours (from time when batteries were inserted or from time the C/F key was pressed/held).
2019-12-30 04:56:01 Nuttig (4)