Alle berichten

nabla yes, you propably have a configuration error. Check the ports tab define Uart6 as serial RX and in config tab select serial-rx and then sbus. use the pad that says SBUS. I have had the same problem. was it uart6? i am not shure, but only one of them works as sbus!!

2021-07-21 12:48:08 Nuttig (1)
Verzenden
antwoorden (3)

Q: can i fly 2207 1900kv motors on 6s? can handle it? xiexie

gevraagd door LeoLuis op 2020-10-02 01:40:24

nabla yes, but here is my advice: dont ;) These are not very melt-proof. These are rather cheap. user 2206er 1800kv-is motors. Your motors seem very very powerful. Better use 45A+

2020-10-02 03:12:30 Nuttig (0)
Verzenden
antwoorden (2)

Q: does the D8 FrSky Version work with the LBT Version of the Taranis X Lite?

gevraagd door protagonist1000 op 2020-07-13 02:34:31

nabla LBT is D16, you need to flash D8 on your sender if it does not have it (in the menux next to where you bind stuff). Search a yt video where someone flashes D8 on the same type of transmitter. If it exists -> proof(it does work), it if does not exist -> kind of proof that it does not work. Anyways I flashed beta flight 4.1 on it (which i recommend besides JESC 48khz!!!) and you can just select betwen D, X and LBT which is D8, D16-FCC and D16-LBT

2020-07-13 03:15:15 Nuttig (0)
Verzenden
antwoorden (1)

Q: VTX table for betaflight. Does any one have a link?

gevraagd door nabla op 2020-06-05 03:54:29

Taradiddle i wanna know

2020-07-03 05:52:24 Nuttig (0)
Verzenden
antwoorden (1)

Q: how to setup smart audio? i can not get it to work on bf (4.1.1)

gevraagd door nabla op 2020-03-22 08:01:11

mgamba hi there. I've managed using Butterflight. something related to SA protocol not entirely implemented. it was working not bad.

2020-03-22 08:39:28 Nuttig (0)
Verzenden
antwoorden (2)

Speedyreedy Lateanswer - but hopefully helps others. There's a setting in betaflight for arming angle. This needs to be set to 180 degrees or else the quad won't arm when it's upside down.

2020-01-21 05:22:07 Nuttig (0)
Verzenden
antwoorden (1)

boTy I have the same problem and I haven't been able to fix it...

2020-01-20 02:11:52 Nuttig (0)
Verzenden
antwoorden (1)

webternals Makesure that you have Soft Serial Turned on. I never could get this VTX to work with soft serial but others have been able to. I have changed to a much better VTX and I recommend you do the same. The output on this thing is horrible at best.

2019-09-25 11:53:41 Nuttig (2)
Verzenden
antwoorden (1)