Alle berichten

Q: What is the diameter of the tail boom? 12 or 14mm?

gevraagd door Paul Kahler op 2020-02-18 01:07:14

Headlong 1.5cm

2020-02-20 02:40:30 Nuttig (0)
Verzenden
antwoorden (1)

Q: this is for part ender 3 pro ?

gevraagd door afook op 2019-09-06 02:47:40

Paul Kahler Yes but you can't use the one spring pneumatic fitting, it got collision with the Z axis

2019-10-22 12:20:26 Nuttig (1)
Verzenden
antwoorden (8)

Q: can I use this for ender3

gevraagd door Gani 8106 op 2019-10-06 12:59:40

Paul Kahler Yes, but you can't use the spring fitting, cause this got a collision with the Z-axis. Second thing, you can't use a extruder wheel. You cannot fit a wheel on the motor shaft, because the new gear is to big.

2019-10-22 12:18:25 Nuttig (0)
Verzenden
antwoorden (1)