Wanneer u een website bezoekt, kan deze informatie in uw browser opslaan of ophalen, meestal in de vorm van cookies. Deze informatie kan over u, uw voorkeuren of uw apparaat gaan en wordt meestal gebruikt om de site te laten werken zoals u verwacht. De informatie identificeert u meestal niet rechtstreeks, maar kan u een meer gepersonaliseerde webervaring bieden.
Omdat we uw recht op privacy respecteren, kunt u ervoor kiezen om bepaalde soorten cookies niet toe te staan. Het blokkeren van sommige soorten cookies kan echter van invloed zijn op uw ervaring van de site en de diensten die we kunnen aanbieden.
U staat: toe
Strikt noodzakelijke cookies (verplicht)
Deze cookies zijn noodzakelijk zodat u op onze website kunt surfen en de fundamentele diensten ervan kunt gebruiken, en hiervoor is uw toestemming niet vereist. Met deze cookies kunnen wij u de essentiële functies van de website aanbieden (accounttoegang, gebruikte taal, gespeelde bestelling, betaling etc), en kan ook worden gebruikt voor identiteitsverificatie en beveiliging. Als u deze uitschakelt, kunnen we niet aan uw basisverzoek voldoen.
Deze cookies verzamelen anonieme informatie over uw online bedieningsgedrag die ons helpen de websiteconstructie te verbeteren. Als u deze cookies weigert, is het mogelijk dat u bepaalde functies van onze websites en diensten niet kunt gebruiken.
Deze cookies stellen ons in staat om de keuzes die je hebt gemaakt over je voorkeuren te onthouden, zoals welke taal je voorkeur heeft. Als u deze cookies weigert, kunt u het gevoel hebben dat de efficiëntie van het surfen op het web is afgenomen.
Deze cookies voeren gepersonaliseerde activiteiten uit om reclame te maken voor producten en diensten waarin u geïnteresseerd bent. Als u deze cookies weigert, krijgt u nog steeds advertenties te zien die niet zo relevant zijn voor uw interesse of vraag.
josn0 Themodule is pre-flashed with a (simple) demo camera webserver. Power it on (using 5 V on the 5V power pin (near the reset button) and ground on one of the GND pins). Then find the new accesspoint with your laptop or phone (forgot the name, but you'll find it). Point the browser to 192.168.4.1. I think it was http://192.168.4.1/jpg for a picture, http://192.168.4.1/jpg_stream for a stream. If you have a USB-serial cable, connect that to pins marked U0T and U0R (and GND of course), Start some serial communication prog on the PC, set it to 115200 Baud, then poweron the module, or push the reset button. If you have no output, you probably have TX and RX wrong: swap and try again. It shows you lots of boot messages, and ultimately shows you the SSID to connect to, and the URL's to use. Later you install the arduino gui, add the esp32 boards, and try the CamWebServer demo that is included. There is lots of help on Youtube! Success!