helgjohn
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: minimum magnification what is the minimum magnification
gevraagd door Diggers op 2021-08-27 23:38:44
helgjohn 1 to 1
Nuttig (0)
Q: Can this be use with creality ender 3 v prusa?
gevraagd door sanibalise op 2018-11-10 02:22:50
helgjohn pendingon clearance if there are rom for it size wise, if your printer can handle 235 X 235 m.m. build plate it will fit. to be sure you need to measure in all directions and make sure it fits in all positions. also keep in mind this will be a custom ting that you will be the tester for and unforeseen issue my apply not covered buy any warranty..
Nuttig (1)
Q: how much temperature achieve..?
gevraagd door Kkv op 2021-06-12 07:38:32
helgjohn Whit40 watt of power it will be possible to get up to 300 deg C but not recommended it will not handle high temp over time. so sensible considered safe sone is between 19 to 235 deg C.
Nuttig (0)
Q: Does this fit the original Creality CR-10 for a Z-axis upgrade?
gevraagd door CrispyDuck op 2021-03-22 17:46:54
helgjohn yes fits like a glove
Nuttig (0)
helgjohn Its between 40 to 45 DB depends on how its mounted.
Nuttig (0)
Q: Does the supplied 1602 LCD Display Screen support IC2 protocol ?
gevraagd door Enrico Bisello op 2020-05-13 23:17:44
helgjohn no
Nuttig (0)
Q: Is this work with raspberry pi 3 model B?
gevraagd door Mrhashim op 2021-02-03 12:33:47
helgjohn -Supportsany revision of Raspberry Pi (directly-pluggable).
Nuttig (0)
helgjohn I can crimp any and all u shaped connector as long as it fits in the crimp groves , But keep in mind this is not a pro tool as you my need to crimp in 2 turns as the dye is not wherry wide so this is more a tool that is for use once here and there or where space is an issue..
Nuttig (0)