Deegeetee This runs on AFHDS2 protocol. FS-i6 & FS-i6x uses both protocols, so are both suitable for this reciever

Deegeetee Airframe & power system supplied. all you need to complete the build is the radio system & battery. The receiver needs to be a combined receiver & servo brick, compatible with your transmitter.

Deegeetee You don't need cables to use this, it utilizes the balance port on your lipo

Deegeetee The transmitter can use AFHDS 2 and AFHDS., so yes, but you may have to switch the Fs-i6x to the AFHDS protocol in the radio settings for the model you wish to use it in, as I believe this receiver brick uses AFHDS.

Deegeetee The FSi6 does both AFHDS & AFHDS2A, so you should have no problem. You can find the correct place to locate the switch between the two protocols in the RX settings.

Deegeetee You should also check that you have your transmitter set as AFHDS 2A and not in the older AFHDS protocol. If you have, all the other answers are valid & will work.

Deegeetee If you can use the original Flysky & Turnigy AFHDS (not AFHDS2) protocol on your T8SG, then it will bind. If not the the Flysky FS-i6 or i6x transmitters can use both AFHDS 2 and AFHDS, so you can switch the Fs-i6 or i6x to the AFHDS protocol in the radio settings for the model you wish to use it in, as I believe this receiver brick uses AFHDS.

Deegeetee Yes you can install 2 different nano sims, plus an sd card