danarrib
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: What is the difference between this BN-220 and BN-180 type?
gevraagd door mazik op 2018-04-16 14:05:57
Q: كم بطارية استطيع وضعها في كل خلية
gevraagd door abuamroamaireh op 2021-02-05 17:52:03
danarrib You can wire in parallel as many as you want.
Nuttig (2)
danarrib This board doesn't work AT ALL.
Nuttig (1)
Q: will it be fine for IPHONE 11?
gevraagd door ilanvasco op 2020-06-26 06:34:34
danarrib Yes.
Nuttig (0)
Q: Is there on RX HDMI output ?
gevraagd door cbjuss@hot.ee op 2020-04-27 22:06:12
danarrib Yes.
Nuttig (1)
Q: Will this work with the Matek F411WSE flight controller?
gevraagd door Wing_Lyfe op 2020-02-28 19:19:42
danarrib Yes, it work. But WSE has only two UARTs, and you will use one for the OSD, so It'll leave only one UART for your receiver, and you wont be able to use another UART dependent device (like GPS).
Nuttig (0)
Q: What is the AWG thickness of the wire? Is it 22AWG or less, such as 24 or 26AWG?
gevraagd door Donald op 2018-09-14 03:38:27
danarrib It is 26AWG.
Nuttig (0)
Q: what is thickness of this?and is this a female to male connector?
gevraagd door theja1000 op 2018-11-30 13:28:37
danarrib It is 26 AWG.
Nuttig (0)
danarrib BN220 is slightly bigger, heavier and expensive than BN180. BN220 has flash memory to store the settings while BN180 doesn't... So BN180 has to be configured every time it's powered on. Usually flight controller software (like Inav) do automatic configuration of GPS module every time it's powered on, so both BN180 and BN220 will work fine.
Nuttig (13)