racer2021
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: would these be small for my 1/16 e revo? or too big
gevraagd door BG501741386 op 2021-12-21 10:33:47
racer2021 They are smaller than erevo tires. Compare the diameter if you would like to know the difference.
Nuttig (0)
racer2021 They are lights that hook up to a power source. You can power them in anything you like as long as you have a power source.
Nuttig (0)
racer2021 No lights just the receiver.
Nuttig (0)
Q: Does this come with nimh or lipo batteries?
gevraagd door BG114038575 op 2021-12-28 18:50:35
racer2021 Mine came with two lipo 2s Gens Ace 1800mah batteries.
Nuttig (0)
racer2021 3s puts the motor over 55,000rpms. I believe that motor caps out at 50,000rpm's. 11.4v would put you at about 50k. With that being said you will probably be ok with 3s if you don't go full throttle until the voltage is lower.
Nuttig (2)
Q: does this version come with all metal driveshafts and metal diffs?
gevraagd door HurkzNZL op 2021-08-27 11:55:49
racer2021 I can confirm as jsanfilippo1975 stated, the rear dog bones are the only metal. I have put some serious miles on mine and nothing has broken. I ordered a complete metal set of everything to go in it but haven't needed to change anything. Being all plastics makes it run really smooth and have very long battery life.
Nuttig (2)
Q: Is there an esc i can upgrade to ? I would like to run 3s 2200mah. Are there parts available?
gevraagd door BG181056541 op 2021-05-18 20:57:19
racer2021 I run my q902 on 3s all the time with this esc. It strips spur and pinion gears like every 5 packs or so but no issues with the esc. I use 850mah 75c 150c burst Tattu lipos with an adapter from xt60 to T-Plug. Again no electrical issues the motor gets a little warm but not bad.
Nuttig (2)
racer2021 says 4500kv in the description
Nuttig (0)