BG332373951
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: Hello, Is this cable create a paralell connection between the motors, or serial?
gevraagd door tsoft op 2022-06-14 01:24:59
BG332373951 Itis parallel connection for 2 steppers to one board port.
Nuttig (0)
Q: Any chance these work on Anycubic Mega Pro!?
gevraagd door MarckOliver op 2022-10-18 03:41:26
BG332373951 I think not. One of silicon column is sorter than other 3.
Nuttig (0)
Q: Can I run several LED strips off one WeMos board?
gevraagd door BG218056221 op 2022-03-30 16:26:49
BG332373951 Yes you can if use external power supply for led strips. 5V pin of D1 mini is not capable to supply a led strip.
Nuttig (0)
Q: Will this work with Alfawise U20 one?
gevraagd door Audenhuff op 2021-01-17 01:05:26
BG332373951 Probablybut you have to check your board connections and your firmware. Will not work without proper firmware.
Nuttig (0)
Q: Would this product be compatible with the geeetech a20m?
gevraagd door BG411723169 op 2021-11-15 23:09:54
BG332373951 Seemsto be compatible. Same extruder kit, but you need to check your steps of extruder in firmware.
Nuttig (0)
BG332373951 Yesit is compatible. Yes it needs firmware that will support BLTOUCH. No it is not plug and play. You need to look at github of BIGTREE. It has pictures for connections. You don't need ISP programmer and little board.
Nuttig (0)
BG332373951 No you can not! For up to 3A you must use a LM2596 for step down (with heat sink) or XL5009 for step up (with heat sink)
Nuttig (0)
BG332373951 If X axis is 2020 extrusion probably does. Be aware of timing belt length. Also you should look out of hot end compatibility
Nuttig (1)