RS2VN
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: what is the total width of the three cables toghether? thank you
gevraagd door niconico op 2021-09-25 02:14:38
RS2VN when 230 is visible means that you have chosen 230V input
Nuttig (0)
Q: What wire gauge should I use for the battery connector and the ESC connector?
gevraagd door Christian Schneider op 2020-11-05 10:14:03
RS2VN Depends on the ESC and battery C. To be on the safe side use the same as it is on the ESC. If there is none, 14 AWG would be OK in most cases.
Nuttig (0)
RS2VN basically UART 3 is vacant and should work. I suggest that you follow the schematics and connect crossfire to UART 6. Use UART 3 for VTX (smart audio or IRC Trump).
Nuttig (0)
Q: can i know how to wire it? i burned already an FC.
gevraagd door Gianluca Puntara op 2019-03-03 05:31:00
RS2VN GNDto GND (FC), 5V to 5V (FC), PB- to B- (FC), Din to LED (FC)
Nuttig (0)
Q: am I correct in saying this firmware is FuryF4OSD (Diat)?
gevraagd door mariomazzanti23 op 2020-02-06 05:57:09
RS2VN Yes.But I have switched back to legacy (3.5) since 4.1 behaved creasy.
Nuttig (0)
RS2VN cca 3.7 mm
Nuttig (0)