IAmBastian
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: Is the stack compatible with the DJI Digital System?
gevraagd door BG434810425 op 2021-08-05 04:43:19
Q: What is the diameter of the screw head?
gevraagd door vipulan op 2018-11-23 20:19:31
IAmBastian 8mm
Nuttig (0)
Q: one or 4pcs
gevraagd door dsbisht233 op 2019-06-11 08:41:55
IAmBastian one pc
Nuttig (0)
Q: How do I get the bits from the case? They all seem to be locked in their holders and won’t come off?
gevraagd door OzBlueDragon op 2018-12-12 20:55:02
IAmBastian move them to the bottom position of the clip. There's a small opening where you can slide it through to get it out with a small wiggle
Nuttig (1)Q: Will this be the repair of mobile
gevraagd door Sonusjjaiswal28 op 2019-03-02 21:45:22
IAmBastian The bits will work on pretty much all phones
Nuttig (0)
IAmBastian You need to screw the clip on pretty tightly. It will then bend the inner clips to stop the bit from moving inside
Nuttig (0)
IAmBastian Push the bits to the bottom of the holder and then you can (with a bit of wiggling around) get them out
Nuttig (0)
IAmBastian Theseare basic, PWM, ESCs. They are not really programmable in any way cause they are meant to be used directly with a receiver. Creating a PWM sinal with an Arduino is really easy, however, so controlling this ESC with an Arduino/ESP is easy.
Nuttig (2)
IAmBastian Yes, it works fine with the Digital FPV system. You just need to know how to wire it and set it up in betaflight (DJI Preset works flawlessly)
Nuttig (0)