Juliano85
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Juliano85 I wouldn't risk a 30amp esc (unless you have a separate UBEC for your servos). I used a 50amp esc with a 10x7 prop.
Nuttig (0)Q: Cw or ccw?
gevraagd door BG223217401 op 2020-04-14 06:47:52
Juliano85 Thread on spinner is suited for ccw. but you can just swap the wires for cw spin.
Nuttig (1)
Q: Will it work with the 60A esc
gevraagd door BG573254124 op 2020-04-26 00:53:37
Juliano85 Yes, although 40 amp would be fine.
Nuttig (0)
Q: will it work in rc plane with servo motor
gevraagd door Dap op 2019-04-05 23:02:54
Juliano85 Yes, it supports servos. it has an inbuilt UBEC.
Nuttig (0)Q: what is maximum continuous power output of this motor? I am using 3s Lipo with 10x7 prop.
gevraagd door kalpsmn711 op 2020-01-18 05:10:28
BG531516391 General rule for rc aircraft motors is 150 watts for every 50g of motor so this would sit around the 300w mark. After testing seems about right.
Nuttig (0)Q: which esc should I use on a 4s Battery?
gevraagd door BG403716142 op 2020-06-17 20:11:40
BG531516391 40 amp should be fine. I used to 50a to be on the safe side - after a full test run on 4s battery for 2 mins the esc was only warm not hot.
Nuttig (1)
Juliano85 no
Nuttig (0)