BlueBlaze6335
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
BlueBlaze6335 I received all the tpu parts as shown in the pictures. the camera mounts , motor dampeners and also the antenna mounts.
Nuttig (0)
BlueBlaze6335 Yes ! According to the manual , vtx should be connected to the 9V. Most vtx can take Vbat or the voltage from the battery. But it is recommended to use something between 8-12V for stable video without noise. So if you are using nano vtx , which usually take 5V as input , you should connect it to a 5V pad , which is present next to the vtx pad on the fc !!
Nuttig (0)
BlueBlaze6335 The best and safe lipo for these motors is 3s. 2s feels a bit underpowered and 4s might make the motors hot !! 3s is the sweet spot and these motors run really smooth on 3s.
Nuttig (0)
BlueBlaze6335 Sure !! any motor with a mounting of 12x12 can be used in this quad. I personally use 1306 and 1507 motors with this frame.
Nuttig (0)
Q: che eliche bisogna montare?
gevraagd door afaccin op 2021-09-01 05:48:50
BlueBlaze6335 you can use 3-5.1inch propeller with a T mounting system. the motor comes with separate 2 long screws for the propeller !
Nuttig (0)
Q: Where can I get the camera mount found in the last picture, the one that has two contact points?
gevraagd door BG108101178 op 2021-05-07 08:24:08
BlueBlaze6335 You get the 3d printed mounts along with the frame and if you just want the camera mounts you can search for them in thingiverse or other websites where you can get the stl or 3d files.
Nuttig (0)
Q: 4 pcs right?
gevraagd door Jerry Avillanoza op 2021-08-25 04:31:01
BlueBlaze6335 Yes. you will get set of 4motors in 4 separate boxes.
Nuttig (0)
BlueBlaze6335 yes
Nuttig (0)