GS-AT6-M Digitale RF Attenuator Module HMC624A 0,5dB Stap Nauwkeurigheid met Type-C Interface en Attenuatie Sterkte Display voor Industriële Communicatie Instrumentatie Beoordelingen

GS-AT6-M Digitale RF Attenuator Module HMC624A 0,5dB Stap Nauwkeurigheid met Type-C Interface en Attenuatie Sterkte Display voor Industriële Communicatie Instrumentatie

US$24.99

Nu kopen

Klantbeoordelingen

3.67 van5

Bekijk alle beoordelingen van3

Schrijf een beoordeling Ontvang dubbele banggoodpunten als je één van de 3 eerste beoordelingen plaatst!

Alle beoordelingen(3)
Afbeeldingen
Videos
Ster
- Ster(3)
- 5 Ster(1)
- 4 Ster(1)
- 3 Ster(0)
- 2 Ster(1)
- 1 Ster(0)

Sorteren op:

Top recensie

Top recensie
Meest nuttig
meest recent

Recensies alleen uit uw land (United States)

Toon origineel

Een deel van de recensie is automatisch vertaald.

marcarVIP5
ES
12/01/2024

Well constructed device, only powered up for testing but not with signals and meters yet. Special care must be taken not to exceed power input limit

Well constructed device, only powered up for testing but not with signals and meters yet. Special care must be taken not to exceed power input limit

Well constructed device, only powered up for testing but not with signals and meters yet. Special care must be taken not to exceed power input limit
0

Reacties

Toon origineel
eianbroVIP4
GB
11/12/2025

0-30dB attenuation is achievable manually by rotating potentiometer shaft. Display does not work in this mode. Suitable software needed to digitally control attenuation and probably for display to work. +3.3 or 5 volt supply required via USB-C socket required even for manual operation. Tested using attenuator on input to my SDR radio receiver and observing change in signal strength. A version without display would have been sufficient for my needs.

0-30dB attenuation is achievable manually by rotating potentiometer shaft. Display does not work in this mode. Suitable software needed to digitally control attenuation and probably for display to work. +3.3 or 5 volt supply required via USB-C socket required even for manual operation. Tested using attenuator on input to my SDR radio receiver and observing change in signal strength. A version without display would have been sufficient for my needs.

0-30dB attenuation is achievable manually by rotating potentiometer shaft. Display does not work in this mode. Suitable software needed to digitally control attenuation and probably for display to work. +3.3 or 5 volt supply required via USB-C socket required even for manual operation. Tested using attenuator on input to my SDR radio receiver and observing change in signal strength. A version without display would have been sufficient for my needs.
0

Reacties

Toon origineel