Aluminiumlegering Houtbewerkingsboor Plaatsbevestiging zakgat-jig Boorgeleider Verstelbare ponsbevestiging voor Doe-het-zelf Bench Meubelpositie Handgereedschap Beoordelingen

Aluminiumlegering Houtbewerkingsboor Plaatsbevestiging zakgat-jig Boorgeleider Verstelbare ponsbevestiging voor Doe-het-zelf Bench Meubelpositie Handgereedschap

US$35.99
~~US$79.99~~
Nu kopen

Klantbeoordelingen

3 van5

Bekijk alle beoordelingen van4

5 ster
1 (25.0%)
4 ster
0 (0%)
3 ster
2 (50.0%)
2 ster
0 (0%)
1 ster
1 (25.0%)

Schrijf een beoordeling Ontvang dubbele banggoodpunten als je één van de 3 eerste beoordelingen plaatst!

Alle beoordelingen(4)
Afbeeldingen
Videos
Ster
- Ster(4)
- 5 Ster(1)
- 4 Ster(0)
- 3 Ster(2)
- 2 Ster(0)
- 1 Ster(1)

Sorteren op:

Top recensie

Top recensie
Meest nuttig
meest recent

Recensies alleen uit uw land (United States)

Toon origineel

Een deel van de recensie is automatisch vertaald.

zojsanVIP3
PL
03/01/2024

all it's ok

all it's ok

all it's ok
0

Reacties

Toon origineel
BG441850244VIP1
US
14/07/2024

I was expecting a well engineered product and was a bit disppointed. When I put it together, it did not flow smoothly. The support rods had to be forced into the base. They did not go in smoothly. The same was true of the bit. Once in they worked well. I just not anticipate it would not go together smoothly. The instructions provided were not muych good as they appeared to be for a different model. Your picture on the web site was much clearer and what I used to assemple the jig.

I was expecting a well engineered product and was a bit disppointed. When I put it together, it did not flow smoothly. The support rods had to be forced into the base. They did not go in smoothly. The same was true of the bit. Once in they worked well. I just not anticipate it would not go together smoothly. The instructions provided were not muych good as they appeared to be for a different model. Your picture on the web site was much clearer and what I used to assemple the jig.

I was expecting a well engineered product and was a bit disppointed. When I put it together, it did not flow smoothly. The support rods had to be forced into the base. They did not go in smoothly. The same was true of the bit. Once in they worked well. I just not anticipate it would not go together smoothly. The instructions provided were not muych good as they appeared to be for a different model. Your picture on the web site was much clearer and what I used to assemple the jig.
0

Reacties (1)

Toon origineel