3 stuks Mega2560 1280 Protoshield V3 Uitbreidingsbord met breadboard
Een deel van de recensie is automatisch vertaald.
A bundle of those Protoshields for the Arduino Mega was thrown in my mailbox today. Quality seems Ok - but price a bit high (I dont need breadboard - only the protoshield).
Perfect fit. Awesome product. Totally recommended.
Comme d'habitude pièce bien emballées dans des pochettes antistatique individuelles.
Very nice quality at a good price.
received
Son muy buenas shield para comenzar a conectar experimentos
This expansion board is good however header pins are not soldered properly and many pins were bend probably during shipping. It is not stackable they have strange header pin arrangement. For me more or less useless it was my fault that I did not checked properly and ordered this item. Please note that item is exactly like it is advertised. Thanks
use of square pads on the holes is great as it allows for a combination of suface mount and through-hole devices to be used. Reset switch on top is also a nice addition. The ability to stack these is great - so many shields assume they are going to be in the only device needed although this unfortunately doesn't apply to the Megas extra I/O pins (22-53) altough there are pins for a socket for these lines so they good be run off to an external board if required. Addition of the small breadboard is nice - thought this would be far too small to be of use but I've been surprised how much I've used them for lashing up small test circuits.
2 pin légèrement tordues sur l'une des carte, mais vite redressé. La carte se monte bien sur la carte arduino MEGA A noter qu'il n'y a pas de connecteur sur les entrée/sorties digitales, mais je vais en souder et ça devrait aller.
shield is compatible with Arduino Uno! for soldering this shield is even better than the original uno shield. More 5 Volt/ground pins would be nice Quality is ok, not perfekt