Alle berichten

Q: Are ND4 and ND8 of this filter available?

gevraagd door BG213444350 op 2022-03-02 07:41:00

gleavek If you look on the site there are sellers selling ND8

2022-04-08 03:51:54 Nuttig (0)
Verzenden
antwoorden (1)

Q: Any ETA for opentx 2.4?

gevraagd door Joel Yek op 2020-05-06 04:20:42

gleavek 2.4 shouldn’t be the deciding factor here. If you want the controller then buy it. When 2.4 comes out it will be available on this

2022-02-13 07:12:37 Nuttig (0)
Verzenden
antwoorden (7)

Q: Can i put a crossfire on this?

gevraagd door BG374946491 op 2022-02-13 07:08:50

gleavek Yes very easy

2022-02-13 07:11:39 Nuttig (0)
Verzenden
antwoorden (1)

Q: Can i put a crossfire on this?

gevraagd door BG374946491 op 2022-02-13 07:08:50

gleavek Yes easily. I installed ExpressLRS which is the exact same setup. Very easy

2022-02-13 07:11:20 Nuttig (0)
Verzenden
antwoorden (1)

Q: Will the version with TBS Module be restocked ? If yes, when ?

gevraagd door chagomass op 2022-02-01 12:17:02

gleavek Cheap enough to buy separate rather than wait whilst it’s on offer if I were you

2022-02-02 02:04:04 Nuttig (0)
Verzenden
antwoorden (4)

Q: what receiver should I buy to pair with this?

gevraagd door berkut op 2020-06-23 09:16:59

gleavek It has a built in receiver which most radios with multi protocol modules will connect to. Personally I put a tiny ExpressLRS on mine it’s great range

2022-01-23 01:20:47 Nuttig (0)
Verzenden
antwoorden (3)

Q: What size is the included screw driver?

gevraagd door BG334721463 op 2022-01-08 12:51:04

gleavek It’s a hex screwdriver and small for the screws. I have this set but never even used that as I have my own hex screwdriver which I’d recommend picking up anyway. Can get a set of 4 on here for about £10 and if you’re into FPV which i assume you are buying this they’ll be really helpful.

2022-01-08 03:04:34 Nuttig (0)
Verzenden
antwoorden (1)

Q: para que serve esta caneta ?

gevraagd door BG161732825 op 2022-01-04 07:15:39

gleavek You use this pen to brush on pads or wires before soldering. This helps the solder flow and stick to the pad or wire rather than sticking to the soldering iron tip itself.

2022-01-06 02:44:58 Nuttig (0)
Verzenden
antwoorden (2)

Q: When Do you have TBS version in stok?

gevraagd door bbaris77 op 2022-01-02 03:44:48

gleavek If it’s not in stock I’d just get the PNP version as really easy to solder your own receiver on there and can pick them up as cheap anyway

2022-01-06 02:43:47 Nuttig (1)
Verzenden
antwoorden (2)

Q: Will this connect with Frsky XM receivers?

gevraagd door BG453216542 op 2022-01-06 01:47:38

gleavek No, this is for ExpressLRS only so will need an ExpressLRS EP receiver (or another brand).

2022-01-06 02:43:08 Nuttig (0)
Verzenden
antwoorden (2)