Alle berichten

Q: Does it work with FB-009 fpv goggles?

gevraagd door BG835710201 op 2020-11-10 10:36:03

OzFPVflyer yes it will work with FB-009 goggles. Plug the DVR into the AV out using the supplied cable. You will still have to power the DVR with a 2 cell lipo.

2020-11-10 09:08:47 Nuttig (0)
Verzenden
antwoorden (2)

Q: Will this transmitter work with the S FHSS protocal?

gevraagd door BG252283248 op 2020-11-02 06:13:58

OzFPVflyer No it will not.

2020-11-02 07:39:40 Nuttig (0)
Verzenden
antwoorden (1)

OzFPVflyer Yes it does, it has AV in and AV out. AV in allows recording while AV out can go directly to screen or goggles. Most of these types of DVR can record and give the screen or goggles the picture at the same time.

2020-10-10 10:37:16 Nuttig (0)
Verzenden
antwoorden (2)

Q: Does anybody know how to set time and date at this device?

gevraagd door cappy0815 op 2020-10-05 04:30:03

OzFPVflyer There is NO setting for time and date.

2020-10-06 03:56:21 Nuttig (0)
Verzenden
antwoorden (2)

OzFPVflyer First you need to make sure the motor is turning the right way and the writing on the prop faces the front of the plane. If you have to ask this question then this model is not for you.

2020-09-27 11:21:04 Nuttig (0)
Verzenden
antwoorden (4)

Q: How do you tell when the battery is dead?

gevraagd door BG153221210 op 2020-09-19 01:27:58

OzFPVflyer When flying the quad you will have about 4 mins of flight time and then the quad will slowly descend as the battery will have no power left. It has auto cutoff so your battery will be fine. You just charge it up again and off you go. You really need to buy at least 4 or 5 batteries to enjoy this type of indoor model and it can also fly outdoors on a still day.

2020-09-20 04:12:38 Nuttig (2)
Verzenden
antwoorden (1)

Q: che tipo di smartaudio ha?? 2.0 o 2.1

gevraagd door Beverly8007 op 2020-09-16 04:27:13

OzFPVflyer TheSmart Audio is authorised by TBS so whatever protocol they use is the same as this.

2020-09-18 02:12:06 Nuttig (0)
Verzenden
antwoorden (1)

OzFPVflyer Youdont need to use a connector, just solder your wires to the Vtx. 5V Cam powers the camera, GND is the ground (black wire) that goes to camera, Video (yellow wire) goes to Camera, GND and 7-26V are the power leads from either battery or power distribution board that powers the Vtx. You can see where to solder the wires just below all the writing on the vtx, dont use too much solder and dont bridge the connections. Hope this helps and its easy to do.

2020-09-18 02:09:15 Nuttig (1)
Verzenden
antwoorden (1)

OzFPVflyer No,it is not possible as the Hitek Transmitter does not have a 5th channel with a 3 position switch. My advice to you is to buy a FRsky I6 radio with receiver (IBUS). There are lots of videos on youtube to show you how to setup the radio with Kopilot. Hope this helps.

2020-09-18 02:03:10 Nuttig (0)
Verzenden
antwoorden (1)