Alle berichten

The seller The resistance of the wire is 33Ω per meter, P = U²/R, of out is 4W, it makes sense.

2022-01-11 03:07:52 Nuttig (0)
Verzenden
antwoorden (1)

Kobie Serrch for the tool code like DCMT070204 insert. Most of them are there in 10 pcs packs. You just have to dig a bit. https://www.banggood.com/10pcs-TCMT-16T304-Carbide-Inserts-For-Indexable-Boring-Bar-Turning-Tool-Holder-p-1112072.html?cur_warehouse=CN

2021-12-16 01:25:40 Nuttig (0)
Verzenden
antwoorden (2)

Q: Can it convert also to a lower voltage, e.g. from 12V to 5V?

gevraagd door BG248255361 op 2021-11-12 01:56:07

Kobie I have not received mine jet, but this is a "boost" coverter. It should "step up" the voltage and I do not think it will allow a "buck", "step down action. Obviously with Ohm's law in mind input Watt and output Watt will be near the same less a bit of losses. There are some "buck boost" converters available that will go both ways. for example DD39AJPA 2 in 1 20W Boost Buck Dual Output Voltage Module 3.6-30V to ±3-30V Adjustable Output DC Step Up Step Down Converter Board

2021-11-12 02:21:47 Nuttig (0)
Verzenden
antwoorden (1)

Q: Would a length of 330mm also be possible?

gevraagd door BG391838421 op 2021-11-03 02:28:38

Kobie I'd settle for the 380mm or longer a hacksaw, and some "elbow grease". Just make sure to clamp the cut off side in the bench vice so you do not damage the nice finish on the piece you want to use. NOT easy to start the hacksaw cutting on that shiny surface, but when it bite it goes easy. Use a fine tooth blade.

2021-11-03 03:33:00 Nuttig (0)
Verzenden
antwoorden (4)

Q: What is the storage box material? Aluminium Alloy or plastic?

gevraagd door BG184739408 op 2021-09-13 08:00:26

Kobie The box is good quality plastic with magnets embedded somehow. The tips and handle is kept in the slots so it does not fall out. The box slide in and out of the outer casing with a clip type of mechanism, like when you install a memory card. Push it in and it stay in. Give it another push and it release to open. Very nice and well made. The handle also hold the tips with a magnet so it does not fall out. I'm very happy with the set.

2021-09-13 01:32:04 Nuttig (0)
Verzenden
antwoorden (2)

Q: Can i feed this amp with a 12v 18A computer power supply without any problems ?

gevraagd door NURULLAH_SARI op 2021-07-25 04:14:10

Kobie For sure, it will be a good supply for the amp. You will not have the full output watts but it will be safe. I use a small 12 volt 5 amp supply and it work great. This little one : https://www.banggood.com/Geekcreit-AC-100-240V-to-DC-12V-5A-60W-Switching-Power-Supply-Module-Driver-Adapter-LED-Strip-Light-p-1441620.html?cur_warehouse=CN

2021-07-25 06:14:50 Nuttig (1)
Verzenden
antwoorden (4)