Alle berichten

Hrumque 2020-07-25 07:19:47
0
aanbevelingen
Reacties (0)

Toprecensenten die je misschien leuk vindt:

Hrumque old (typeA) receiver & transmitter is NOT compatible with new (typeB) series. And cannot be paired together.

Mike 2018-07-08 16:34:22
1
Reacties (2)
Hrumque 2019-09-23 13:17:00
0
aanbevelingen
Reacties (0)

Toprecensenten die je misschien leuk vindt:

Hrumque 2019-09-23 13:16:59
0
aanbevelingen
Reacties (0)

Toprecensenten die je misschien leuk vindt:

Hrumque 2018-10-04 11:43:02
0
aanbevelingen
Reacties (0)

Toprecensenten die je misschien leuk vindt:

Q: este equipamento funciona em 60 hz?

gevraagd door Luiz99 op 2017-11-23 04:39:07

Hrumque Will work with 60Hz without problem, because this is brushed motor, works from DC to 400Hz this same way.

2018-07-29 07:00:28 Nuttig (0)
Verzenden
antwoorden (1)

Q: Is it possible to change the collet and use 8mm bits?

gevraagd door gauchn op 2017-12-05 09:38:55

Hrumque No. Not in easy way, because inside hole in motor shaft is smaller than 8mm

2018-07-29 06:58:44 Nuttig (0)
Verzenden
antwoorden (1)

Q: do you sell also a replacement clear plastic base? thanks

gevraagd door srsr op 2018-04-09 02:30:37

Hrumque If you dont find plastic base - bases for makita 3700 series will work great too

2018-07-29 06:57:11 Nuttig (0)
Verzenden
antwoorden (1)

Q: Can the device be consulted in English and a European power supply?

gevraagd door lbodan op 2017-11-13 04:33:12

Hrumque Without anny issue it will work on 230v, just change power plug for your country standard

2018-07-29 06:56:10 Nuttig (0)
Verzenden
antwoorden (2)

Q: Is this available with standar european plug??

gevraagd door Suso op 2018-03-14 04:16:07

Hrumque Cut the wire and make standard 230v plug and done!

2018-07-29 06:55:05 Nuttig (0)
Verzenden
antwoorden (2)

Q: This is 6.0 or 6.3 mm?

gevraagd door cico78rs op 2018-05-17 12:10:44

Hrumque 6.35, 1/4inch

2018-07-29 06:54:33 Nuttig (0)
Verzenden
antwoorden (2)

Q: Does this works for a 12428?

gevraagd door kenlider op 2018-01-04 08:29:58

Hrumque It can work for wltoys 12428, but you must change front shafts to feiyue/jjrc style (wltoys have dogbone, this dif dont have sockets for it,)

2018-02-03 09:04:37 Nuttig (0)
Verzenden
antwoorden (4)

Hrumque You'd better think about using the included nuts because without it - the silver rods will unscrew and get lost. Silver regulatory part should be countered.

GG74 2017-12-11 08:53:27
2
Reacties (1)