BG454018321
mijn inhoud
Alle berichten
Beoordelingen
Reacties
antwoorden
vragen

Alle berichten

5V 650nM 5mW Cross Laser Diode Module
US$2.99 US$3.99

Q: There is a silver wire and a copper wire. Which is positive and which is ground?

gevraagd door PeterLiwyj op 2020-01-15 03:30:07

Peter No the fastest

2020-02-09 11:54:25 Nuttig (0)
Verzenden
antwoorden (1)
Peter 05/05/2019
I build a lot of strange things. These boards come in very handy. They take solder very well and come in standard spacing that lines up with solderless breadboards. Makes it very easy to transfer your temporary breadboard projects to more permanent locations.
Geekcreit® 40 stuks FR-4 2.54mm Dubbelzijdig Prototyping PCB Gedrukte Schakeling
US$9.99
1
aanbevelingen
Reacties (0)
10 stuks 3 mm PZ-101 Mercury-schakelaars Kiepsensor 20V 0,5A Werkhoek 10 graden Eindschakelaar
US$5.95 US$8.10

Q: Why use a picture of the broken one where the mercury has leaked out?

gevraagd door PeterLiwyj op 2019-11-29 08:44:12

deiity Maybe you can use the "contact us " to contact the banggood customer service team.

2019-12-02 12:05:54 Nuttig (0)
Verzenden
antwoorden (1)
Peter 05/05/2019
Well built. You will need a battery holder too. Bat - goes to A- Bat+ goes to A+ Use heavy short wire. These connections go to the outer heavy cone shaped battery connections on the holder. Also connect the thinner sensor wire shown here in red and black. Pay attention to the polarity of the plug. My wires were reversed so I had to take them out and switch them in the plug. I could have just wired it without caring about the color but not everyone speaks English and will only look at the pictures. Sensor wire red positive goes to V+ on the battery holder. Sensor wire negative black goes to V- on the battery holder. These connections go to the small spring loaded pins in the middle of the battery connections. THE INNER AND OUTER CONNECTIONS OF THE BATTERY CONTACTS MUST ALL BE TOUCHING THE BATTERY TO MEASURE EVERYTHING!!! The power from the micro USB is 5V 500mah. Here is a link to instructions on how to use this tester. https://syonyk.blogspot.com/2016/01/zb206-battery-tester.html
ZB206 V1.3 Batterijcapaciteitstester Interne weerstandstest 18650 Lithiumbatterijtester
US$0.00
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Very nice! This is the second one I have ordered. I mounted this one in a small box to make a portable variable power supply. Since the control board comes off I can store it in the box with all the wires. I soldered everything instead of using the screw connectors but those work good too. Great value. Very happy!
B3603 CNC DC-DC Digitale Step Down Buck Module Constante Spanning Stroom
US$15.99 US$19.99
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Perfect replacement for my little radio with a broken antenna. Well built and works smooth. Slightly longer but now it has better reception!
Vervanging 60cm Zes Secties Zilver Telescopische Antenne Lucht voor Radio TV KL
US$8.99 US$10.99
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Very nice! Quite powerful too. I am running 4 speakers in a small ammo can with this. running two 1.5 inch 4 OHM 3 Watt and two 2 inch 10 watt 8 Ohm speakers with 4 inch PVC pipe added to each speaker to make the sound better. Any old laptop power supply up to 24 volts will run this, mine is 19 volts. If you use the plug make sure the positive is in the middle of the connector. It gets quite hot and I may have to add a cooling fan.
2 stuks 1.5inch 4 Ohm 3W Full Range Audio Speaker Stereo Luidspreker
US$12.99 US$15.99
0
aanbevelingen
Reacties (2)
Peter 05/05/2019
Great quality. gold plating and very nice plastic. Took solder quite well. I made a small bench top variable power supply with mine.
Koppelterminals Rode Zwarte Connector Versterkers Bindingspost Banaan Luidspreker Stekker Jack
US$3.00 US$8.99
1
aanbevelingen
Reacties (0)
Peter 05/05/2019
Works very well. Small size but lasts about ten hours on continuous mode which is perfect. Got it as a gift for my mom and she really liked it!
VH 420 ml Usb Desktop Luchtbevochtiger Luchtzuiverende Etherische olieverspreider Touch Control Smart Anti-dry Household
US$25.99 US$31.99
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
This is without a doubt the best upgrade you can make for your 3D printer to lower the amount of noise it makes! I had to reverse my motor plugs because for some reason it swapped the motor direction when I put them in. And make sure you do not put them in backwards! compared to the old drivers these look backwards but they are not. Check your wiring carefully before putting them in. I only swapped out X and Y but the difference in noise level is amazing! Now I need quieter fans LOL! Well worth the upgrade. My printer is quiet as a mouse now!
Geeetech® 2 stuks ultrastille TMC2208 Stappenmotor Bestuurder + Koellichaam + Schroevendraaier Kit voor 3D-printer
US$20.99 US$25.99
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Very nice! Quite powerful too. I am running 4 speakers in a small ammo can with this. running two 1.5 inch 4 OHM 3 Watt and two 2 inch 10 watt 8 Ohm speakers with 4 inch PVC pipe added to each speaker to make the sound better. Any old laptop power supply up to 24 volts will run this, mine is 19 volts. If you use the plug make sure the positive is in the middle of the connector. It gets quite hot and I may have to add a cooling fan.
1 Stks 2 Inch 10 W 8ohm Dual Magnetic Full Frequency Kleine Multimedialuidspreker Louderspeaker
US$7.99 US$10.99
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Very nice! Quite powerful too. I am running 4 speakers in a small ammo can with this. running two 1.5 inch 4 OHM 3 Watt and two 2 inch 10 watt 8 Ohm speakers with 4 inch PVC pipe added to each speaker to make the sound better. Any old laptop power supply up to 24 volts will run this, mine is 19 volts. If you use the plug make sure the positive is in the middle of the connector. It gets quite hot and I may have to add a cooling fan.
TDA7492P Bluetooth-ontvanger Versterker Audio Board 25WX25W Luidsprekers Modified Music Mini-versterkers DIY Dual Channel
US$9.58 US$10.79
0
aanbevelingen
Reacties (0)
Peter 05/05/2019
Very handy. I made a small bench top power supply with some of mine. The connection on the back goes to the middle inner pin which is normally positive. The other two go to the outer contact which is normally negative.
Excellway® JS01 10st 5,5 x 2,1 mm DC-voeding vrouwelijke jack-aansluiting
US$3.99 US$9.99
0
aanbevelingen
Reacties (0)
BG454018321 03/08/2018
Pretty good, worth the $ I spent. Not so expensive I have to worry about it. Perfect for throwing in the bottom of the tackle box.
Sakura 30 * 60 Mini-verrekijker Telescope Blue Film
US$9.99 US$13.63
0
aanbevelingen
Reacties (0)
BG454018321 11/03/2018
Arrived well packed and was undamaged. I even threw it on a granite plate and tested it for any sort of bow or bend. Perfectly flat!
350mm/500mm Lengte 2060 T-Slot Aluminium Profielen Extrusie Frame voor CNC
US$0.00
0
aanbevelingen
Reacties (0)

Jij bent de expert, kan je helpen?

We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!

Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.

Help anderen en wees gelukkiger!

  • Abonneren

Over badges

Badges zijn gerelateerd aan de community en gebruikers verdienen badges door kwaliteitsinhoud te creëren, missies te voltooien of door deel te nemen aan speciale activiteiten. Specifieke mensen hebben ook hun eigen exclusieve badge.
CEO badge

de ceo-badge is alleen in handen van de baas van Banggood.

Badges die je kunt verdienen, komen binnenkort
  • Oké

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • Oké

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe