Cliffyd33
mijn inhoud
Alle berichten
Beoordelingen
Reacties
antwoorden
vragen

Alle berichten

Cliffyd33 10/09/2020
really good brushed board. Amazon is asking like over $90 for this same one. i use these all the time!
Eachine Beecore F3_EVO_Brushed vluchtbesturing voor Inductrix Tiny Whoop Eachine E010 E010S
US$28.99 US$34.99
0
aanbevelingen
Reacties (0)
3D-printer PTFE Tubing Toevoerslang - 3,00 mm 4×6 mm - RepRap
US$7.99 US$9.99

Q: will this work for 2.8mm filliament?

gevraagd door Cliffyd33 op 2020-05-03 07:08:21

WayJJJJ no, it is for 1.75mm filament

2020-05-28 01:26:31 Nuttig (0)
Verzenden
antwoorden (1)
Cliffyd33 19/05/2019
Small, Campact and easy to use. Perfect for miceo Qwad builds and binds to my dx6e no problem!
MOY DS801 DSMX DSM2 Mini-compatibele ontvanger met SBUS PPM-uitgang
US$10.39 US$11.32
1
aanbevelingen
Reacties (0)

Cliffyd33 justset it for ppm (let it blink for 30 secs) provider is easy, just ppm as provider and done. I had same issues.

tglynn 28/08/2017
Using this on a new Emax Babyhawk. Can't get it to bind as DSMX, my DX-8 only binds it as DSM2/22ms (1024) but this could be the DX-8, it is running 3.01 software. One tip is I had to hold the DX-8 about 2 metres away during binding. The MOY runs on 3.3 to 5.5V so connection is simple. In Betaflight you need to set it up as Spektrum 1024 and SBUS as the provider. Another tip is sometimes Betaflight doesn't seem to show the device connected in the receiver dialog. It shows the channels but not the bars. Trick here is to ensure that the Low/Mid/High values aren't zero, Set them to something like 1200/1500/1800 and the "bars" then appear. Range is good. I was flying ~50m away on FPV. Seems like good value.
MOY DS801 DSMX DSM2 Mini-compatibele ontvanger met SBUS PPM-uitgang
US$10.39 US$11.32
2
Reacties (2)

Cliffyd33 isthat an acrylic frame?

fpvant 23/04/2019
okokok not to bad
20x20mm Upgrade Betaflight F4 Noxe V1 Vluchtcontroller AIO OSD 5V 8V BEC met barometer en blackbox voor RC Drone FPV Racing
US$22.99 US$27.99
2
Reacties (1)
Cliffyd33 02/10/2019
very good for the price. would buy more and perfect for brushed builds
Eachine TX06 700TVL FOV 120 graden 5.8Ghz 48CH 25mW Slimme audio mini FPV-camera Ondersteunt Pitmode AIO-zender voor RC Drone Tiny Whoop
US$25.00 US$56.39
0
aanbevelingen
Reacties (0)
Cliffyd33 02/10/2019
must have kit for any diy drone enthusiest
Sulev™ M3NH5 180-delige M3 Nylon schroef zwarte zeskantmoer PCB afstandhouder afstandskolom Assortimentsset
US$13.99 US$16.99
0
aanbevelingen
Reacties (0)
Cliffyd33 02/10/2019
Atleast these ones are a bit better glued
URUAV UR65 FPV Racing Drone Onderdeel SE0603 17000KV 1S Borstelloze motor
US$10.08 US$12.10
0
aanbevelingen
Reacties (0)
Cliffyd33 22/08/2019
This drone is the hottest item on youtube for inexpensive micro fpv racers. cant beat the price for a complete quad. I love mine you just need a reciever and battery obviously. A++++
Eachine Tyro79 140 mm 3 inch DIY-versie FPV Racing RC Drone F4 OSD 20A BLHeli_S 40CH 200mW 700TVL FPV Camera
US$129.99 US$136.99
0
aanbevelingen
Reacties (0)
Cliffyd33 22/08/2019
This is my 2nd one of these rx's I bought, theyre so friggin tiny, they are perfect for the smallest pepperfish or and ultra micro build. Highly recommend this reciever!
Tiny 2.4G 6CH Ontvanger Compatibel met DSM2 PPM Signal Output voor Eachine QX80 QX90 QX95
US$20.99 US$25.99
0
aanbevelingen
Reacties (0)
Cliffyd33 12/08/2019
Very small motors. these are for my ultra micro 1s builds, like the pepperrfish. Its nice because all my brushed coreless motorslike inductrix, the props fit so i have lots of props that fit.
URUAV UR65 FPV Racing Drone Onderdeel SE0603 17000KV 1S Borstelloze motor
US$10.08 US$12.10
0
aanbevelingen
Reacties (0)
Cliffyd33 20/06/2019
nice carbon frame for micro builds. I plan to buy canopy for this as well
DIY Micro FPV RC Quadcopter 100MM Brushed Frame Kit Ondersteuning voor 8520 Coreless Motor
US$13.99 US$16.99
0
aanbevelingen
Reacties (0)
Cliffyd33 20/06/2019
tiny and perfect for my micro brushed builds. I plan to buy a few of these.
Eachine VTX01 Super Mini 5.8G 40CH 25mW FPV-zender voor RC-drone
US$21.00 US$56.79
0
aanbevelingen
Reacties (0)
Cliffyd33 12/07/2018
So easy to use with my radiolink AT9. Plugged it in to my F3 evo with 3 wires and turned on my radio and bound! done!
Radiolink R6DSM 2.4G 10CH DSSS FHSS Ontvanger voor AT9 AT9S AT10 AT10Ⅱ PPM SBUS Uitvoer
US$19.99 US$23.99
0
aanbevelingen
Reacties (0)
Cliffyd33 04/07/2018
long time to get here but it was my post office's fault so no issue with banggood. A+ as usual
2X Eachine 3-bladige Propeller 8Pcs & 8.5x20mm Coreless Motor 4Pcs voor DIY Micro FPV Quadcopter Frame
US$10.99
0
aanbevelingen
Reacties (0)
Cliffyd33 17/06/2018
Bangood sent me this replacment board for me right away without any hassles!
Micro 32bits F3 Gebroken Flight Control Board Gebaseerd op SP RACING F3 EVO Borstel voor QX95 QX90 QX80
US$10.99
0
aanbevelingen
Reacties (0)
Cliffyd33 03/05/2018
I love this little camera, most everyone uses this for micro quad builds.
1/4 CMOS 600TVL 1,8 mm FOV 170 graden groothoek Mini FPV-camera PAL / NTSC 3,7-5 V voor kleine RC Drone FPV Racing
US$10.99 US$19.19
0
aanbevelingen
Reacties (0)
Cliffyd33 16/04/2018
Got this for my step daughter with a bunch other make up. she really likes it and was quite excited to use it so I guess its pretty nice.
Banggood 40 kleuren Mini oogschaduw palet Set Kit Glitter Shimmer Cosmetische draagbare oogmake-up
US$23.99 US$28.99
0
aanbevelingen
Reacties (0)
Cliffyd33 16/04/2018
I use it on my micro drone to feed my txo3 mini fpv cam 5v and seems to clear up motor noise as well for a clear video signal. I think if your gonna fly micro you need one of these
DC-DC 3.7V naar 5V Step Up Spanningsversterker Regulator Micro Voedingsmodule Voor Geborstelde Race Quadcopter
US$2.99 US$8.99
0
aanbevelingen
Reacties (0)

Jij bent de expert, kan je helpen?

We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!

Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.

Help anderen en wees gelukkiger!

  • Abonneren

Over badges

Badges zijn gerelateerd aan de community en gebruikers verdienen badges door kwaliteitsinhoud te creëren, missies te voltooien of door deel te nemen aan speciale activiteiten. Specifieke mensen hebben ook hun eigen exclusieve badge.
CEO badge

de ceo-badge is alleen in handen van de baas van Banggood.

Badges die je kunt verdienen, komen binnenkort
  • Oké

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • Oké

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe