Alle berichten

BG431715225 Choose Ender 3. In the machine settings of Cura, Make the bed 220x220x220. The printer itself can only print 210x210x210 but it will center it on the bed properly. Build Volume=off; gcode=Marlin or RepRap Print head Settings xMin-26 yMin -32 xMax32 yMax34 Gantry10 NumOfExtruders1 Make sure the head is on tight (mine was loose). The side fan should be on permanently. The underside print cooling fan should only go on when you select the print head or during the print. You can print at depths of 0.05mm layer height up to half your nozzle diameter. 0.05 takes ages but produces amazing smooth prints. 0.4mm dia basic pla prints at 205*c with a bed of 50*c at between 40 and 80mmps. Travel speed of 150-200mmps. Speeds and temperatures dependent on delicacy of the print.

2020-10-29 06:32:11 Nuttig (1)
Verzenden
antwoorden (1)

xiaohui The total wattage power supply is about 300W. Maybe you can check this item:https://www.banggood.com/AC-110-220V-To-DC-12V-29A-350W-Driver-Switch-Power-Supply-Transformer-For-LED-Strip-Light-p-1094602.html?rmmds=category

2019-02-02 12:52:27 Nuttig (0)
Verzenden
antwoorden (1)