Alle berichten

Q: Is it possible to set the end voltage to 4.00V or 4.10V per cell?

gevraagd door Jeremy op 2020-08-29 10:24:49

BG924383610 Yes,you could set the end voltage per cell between 3.85V and 4.35V, where 4.20V is default

2022-03-12 11:03:19 Nuttig (1)
Verzenden
antwoorden (3)

Jeremy It has a JST connector for 2S or 3S LiPo. the battery compartment is designed for 4 AA batteries, so the LiPo has to be thin. I'd recommend putting in 2 or 3 3.7V AA rechargable batteries and 1 or 2 "dummy" AA batteries that only act as a wire.

2021-04-23 12:04:36 Nuttig (0)
Verzenden
antwoorden (2)

Q: Distance between front and rear wheel centres.

gevraagd door jarndice op 2020-06-21 03:58:41

Jeremy The wheelbase is (150 ± 2) mm

2021-03-19 02:18:15 Nuttig (0)
Verzenden
antwoorden (1)

Jeremy Yes, you can use several identical cars at the same time in the same place. Just turn on each car and controller together before turning on the next car or controller.

2020-09-04 06:33:19 Nuttig (0)
Verzenden
antwoorden (13)

Jeremy The Ch5 and Ch6 knobs are full potentiometers just like with the X6FG. They should give you standard full range of motion with a servo or ESC.

2020-07-30 06:27:11 Nuttig (0)
Verzenden
antwoorden (3)

Q: This servo fit on Wltoys 144001?

gevraagd door maurosantos op 2020-05-29 10:44:55

Jeremy It's 1 or 2 mm wider than the original servo, but it should fit if you file the mounting bracket a bit. Make sure you have a receiver with standard connectors.

2020-07-06 09:44:22 Nuttig (0)
Verzenden
antwoorden (2)