Alle berichten

Q: What is the max RF Power for this bridge?

gevraagd door BG172101915 op 2022-01-17 11:27:44

BG321646142 Documentation indicates 100 W

2022-02-01 05:21:01 Nuttig (1)
Verzenden
antwoorden (2)

Q: Is this chip genuine FTDI or clone?

gevraagd door BG172101915 op 2021-02-07 10:52:48

WolfxPac how do you differentiate between them? it's open-source hardware using same USB to TTL IC.

2021-09-17 12:19:16 Nuttig (0)
Verzenden
antwoorden (2)

Q: I am confused...are these straight or curved (or is it random)?

gevraagd door rbusque op 2018-11-05 07:27:07

AIANTONIA Curved head

2018-11-14 08:51:16 Nuttig (1)
Verzenden
antwoorden (2)

Q: What is the measurement frequency for this unit?

gevraagd door BG172101915 op 2020-02-28 12:37:22

BG555247215 Thisdevice measures earth ground resistance, not the frequency

2020-11-05 01:14:14 Nuttig (0)
Verzenden
antwoorden (2)

Q: What is the diameter of

gevraagd door rbusque op 2018-03-28 07:10:50

PampaWak About8mm. Please permit me 1-3cm of tolerance because of manual measure.

2020-05-05 12:07:28 Nuttig (0)
Verzenden
antwoorden (1)

Q: What is the diameter of ceramic insulator protecting the wires?

gevraagd door rbusque op 2018-03-28 07:11:37

PampaWak Idon't know exactly, but it's about 8/10mm. Sorry for this delay, but I didn't know about this part of the website!

2019-10-18 04:55:37 Nuttig (0)
Verzenden
antwoorden (1)

Q: What is the diameter of the ceramic tube?

gevraagd door rbusque op 2018-03-28 07:14:18

Sandu max12.4mm, min 10.4 mm - is eliptic, not round

2019-09-17 09:25:32 Nuttig (0)
Verzenden
antwoorden (1)

Q: nela pode por 2 filamento ao mesmo tempo ?

gevraagd door ????????? op 2019-08-11 07:20:32

rbusque Natively,it can only handle one filament at a time. This being said, my impression is that these are highly modifiable.

2019-08-12 07:53:23 Nuttig (0)
Verzenden
antwoorden (4)

rbusque Minedid not have magnetic platform. When I researched the resume function for this, though possible, it was clear there would always be some artifact in the print...I opted to not enable it. Printing can be done directly from the micro SD. Extruder is nothing fancy. I ended up installing a bed sensor for levelling...made a huge difference in repeatability.

2019-08-12 07:50:56 Nuttig (0)
Verzenden
antwoorden (4)