Alle berichten

franazzo Are you up and running? I still try to figure out the power adopter!!! Where is the power, plugs into the controller? I can not find a diagram anywhere to hook it up the laser to my shapeoko3 . :-(

franazzo 09/01/2021
1
Reacties (2)

Q: Is there a instruction video for hooking it up to a cnc?

gevraagd door franazzo op 2021-09-26 09:01:19

philouarcos Hi, Perhaps is anywhere a video but I didn't need it, while I red the included notice and all connections are clearly marked on the board with e.g. +, -, PWM,... There is no surprise if you're already competent in CNC...

2021-09-28 12:13:14 Nuttig (0)
Verzenden
antwoorden (1)