Alle berichten

BG353518574 Twoother things: 1) Updated firmware is non-extant. I had to configure and compile a new Marlin fw from scratch using gathered information from an older config file. It was a tedious process not suitable for a beginner. 2) My hotehd keeps jamming and I can't figure out the cause despite trying literally every advice found on the web. Somehow heat creep develops and jams the filament inside the tube. My only remaining solution is to upgrade to another type of hotend (thinking about dragon).

BG353518574 15/08/2020
3
Reacties (2)

Q: does this come with software to be able to design parts

gevraagd door BG361025229 op 2021-01-03 03:56:20

BG353518574 No.It doesn't come with any SW whatsoever. For 3d design, you may use Fusion 360 for personal use, OnShape, SketchUp free, SelfCAD, TinkerCAD, FreeCAD, Blender, etc. It all comes down to your preference or modeling skill. For slicing, you may use Cura or any other freely available slicing SW.

2021-01-04 07:37:05 Nuttig (0)
Verzenden
antwoorden (1)