Alle berichten

janogumpetung And even more parts.... Mine came with a 2Xsteel plates and PEI sheets, many additional nuts and bolts and a silicone hot-end protector (very helpful to get successful prints and avoiding blobs of death). Remember the plastic parts must be for the BEAR.

2022-01-27 01:35:37 Nuttig (0)
Verzenden
antwoorden (3)

kenanjo The frame is very straight forward to build compared to the ones with plates. No measuring at all, just put the bolts in. But if like me the excitement took over you then have to then take them out again, insert a T nut, put the bolt in, repeat many time. If you really need instructions, Search for "FYSETC bear" to find more detail to build the frame. Avoid the multiple build by reading the bear assembly from Gregason at least 3 times and note where all the t nuts go before you build the frame.

2021-03-21 07:22:12 Nuttig (0)
Verzenden
antwoorden (1)