Alle berichten

Q: How much does the whole assembly (motor + gears + thread) weigh?

gevraagd door RIANGOUWSAJ op 2020-04-04 03:14:39

Naturanolimit Itis very little and the weigt is only few gramms but, I'm sorry. I just mount it in my mycroscope and can't say you the correct weight.

2020-12-16 09:42:59 Nuttig (0)
Verzenden
antwoorden (2)

Q: does it switch the boiler on and off?

gevraagd door broger op 2020-11-15 09:15:45

Naturanolimit Yes.I drive two electric valvle but you can use it for boiler. Take a look for the Amper you can put in the rel

2020-12-16 09:40:07 Nuttig (0)
Verzenden
antwoorden (2)

Naturanolimit Idon't know his impedance in ohm but use it as an 8 ohm impendance in a musical box for instrument and music. I drive it with an Monocore ampl of 100 w and it go well. The sound is enougth clear. Give the correct middle higth inflection in the sound. I use it with other three speakers for bass, treble and higt frequency. For the price you could just prove it. I'm happy to use it.

2020-12-16 09:37:42 Nuttig (0)
Verzenden
antwoorden (1)

Q: Is there an output 2 volt? How mutch Ampere nu 2 VOLT?

gevraagd door JohannesSchur op 2019-10-21 12:22:20

Naturanolimit Idon't measure it but you have to take low the input if you want 2 volts.

2020-09-06 12:35:33 Nuttig (0)
Verzenden
antwoorden (2)

Q: Hi Seller, do you have the power supply for this? Thanks

gevraagd door BG104514475 op 2020-08-24 05:16:57

Naturanolimit I'mnoty a seller but i bought the power supply on banggood.

2020-09-06 12:32:43 Nuttig (0)
Verzenden
antwoorden (1)

Q: it doesn’t work with 220v

gevraagd door Paul op 2020-08-28 12:18:11

Naturanolimit Yesit works with 220. You have only to pay attention to the electrostatic discharges from lightning. Take of the plug when it's raining.

2020-09-06 12:30:19 Nuttig (0)
Verzenden
antwoorden (1)

Naturanolimit No.I'm not a seller, but you could bye it in a seller site as ali baba or other. I bye it there.

2020-03-24 05:07:53 Nuttig (0)
Verzenden
antwoorden (1)

Q: does this module feature PFC?

gevraagd door peterjazenga op 2019-07-22 07:54:50

Naturanolimit I'msorry. I don't know if it respect PFC.

2020-03-12 04:52:28 Nuttig (0)
Verzenden
antwoorden (2)

Naturanolimit Thereis a choosing near the voltage in the up right corner.

2020-03-12 04:50:12 Nuttig (0)
Verzenden
antwoorden (2)

Naturanolimit Ils'agit uniquement d'un signal d'attention indiquant que l'alimentation fonctionne. Moi aussi, je pensais que cela pourrait tre un signal de dysfonctionnement, mais ce n'est qu'un signal d'attention. Je prie pour rien.

2020-03-12 04:47:54 Nuttig (1)
Verzenden
antwoorden (3)

Q: is the motor reversible by switching polarity?

gevraagd door tushaar vishnu op 2019-02-27 12:32:02

Naturanolimit Yes.The motor can rotate in the two direction.

2020-03-04 01:38:43 Nuttig (0)
Verzenden
antwoorden (3)

Q: is it plastic

gevraagd door martis.elton op 2019-09-16 05:00:16

Naturanolimit Yes.You can see the footprint of the mold.

2020-03-04 01:36:16 Nuttig (0)
Verzenden
antwoorden (1)

Naturanolimit Youcan't use it without a copper tube cause temperature. For a bug the water pump stopped and I've seen smocking the copper tube. You need a cooling system. For length you have to use the same impedance. you can use a program to calculate the length of the bobbin as it suits you. But it is important you respect impedance. I use my ZVS to get up temperature bares of iron but when temperature go up the curie point stop conduction. The iron reach red color and you can fold it but I think that you don't reach 1500 deg with iron because when it goes near this range the conduction fall down. You cant fuse iron but could fuse copper or aluminum for best conduction of materials. Is is very good for reach iron red color and fold it. Only 10 sec for a bare 15x3 mm for a length of 10 cm. Regard.

2020-02-22 11:28:26 Nuttig (0)
Verzenden
antwoorden (1)