q500dude
mijn inhoud
Alle berichten
Beoordelingen
Reacties
antwoorden
vragen

Alle berichten

Rotary Encoder Module Board voor Arduino Brick Sensor Development Ronde Audio Draaielement Knop Cap EC11
US$2.99 US$6.54

Q: Are a mounting nut and washer included in the packaging?

gevraagd door q500dude op 2022-02-05 11:22:50

paul Yes, mine had both.

2022-02-10 04:45:12 Nuttig (0)
Verzenden
antwoorden (1)

q500dude Yes.Description calls out ONVIF support and it doesn't have it as far as I can tell. I did upgrade the firmware as the Tuya app told me to. Possibly the new firmware removes support?

DenizOktay 02/07/2021
The first products I bought were good. I bought 3 to try. It came as in the description. It had onvif support. The next 12 units I bought do not have onvif support. Same product as image and box, different product as feature. I was not satisfied at all. We're still trying to find a solution. We were totally disappointed.
Tuya RPP06 1080P PTZ Draadloze WiFi IP Camera TF-kaart Tuya Smart Home Voice Intercom Nachtzicht Beveiliging Waterdichte Pan Tilt IP Camera
US$39.00 US$47.99
2
Reacties (2)
q500dude 02/09/2019
Really warm. Only need to turn on for a few minutes and they heat up very quickly and stay warm for a while. I used a powerbank and it doesn't use much power at all.
5V 2A Elektrisch Verwarmde Voetinzool USB Voet Verwarmer Ademend Wasbaar en Bijgesneden Deodorant Met Adapter
US$15.99 US$19.99
4
aanbevelingen
Reacties (0)
FrSky Telemetriesysteem Toebehoren Batterijspanningssensor FBVS-01
US$9.99 US$10.99

Q: Does it work with 2s lipo?

gevraagd door BG443716541 op 2020-06-16 03:25:06

q500dude Yes it would. It is simply a resistor based voltage divider. Resolder to the lowest setting. If you are using a flight controller then put a multimeter on the voltage and the go into the flight controller settings and adjust the calibration value to get the numbers to match.

2020-06-17 08:53:00 Nuttig (1)
Verzenden
antwoorden (3)
ESP01/01S-adapterbord Breadboard-adapter voor ESP8266 ESP01 ESP01S-ontwikkelingsbord
US$5.99 US$7.99

Q: Is the label of this breakout board are correct? I test it with multitester and seems that VCC label on the breakout is on GND of ESP01, and so on.

gevraagd door BG453216541 op 2020-06-03 03:14:59

q500dude There's a little arrow next to the socket that indicates which way the 01 goes. Not intuitive. I thought it should go over the connectors too, but then noticed the arrow.

2020-06-03 10:01:07 Nuttig (1)
Verzenden
antwoorden (1)
Bakeey TPU Watch Charger horlogekabel voor Bakeey S10 S09 Smart Watch
US$12.72 US$15.99

Q: Will this cable work for the Bakeey SN58 watch? My existing cable got a short circuit and melted. I have contact CS as well.

gevraagd door q500dude op 2020-05-19 08:03:22

TinyCutie Sorry,it only fit for s10 s09 smart watch.

2020-05-27 06:21:15 Nuttig (0)
Verzenden
antwoorden (1)
Geekcreit 0,96 inch 7-pin HD kleuren IPS-scherm TFT LCD-display SPI ST7735-module
US$5.99 US$15.99

Q: Arduino libraries ?

gevraagd door feiticeir0 op 2019-01-11 05:07:27

q500dude I used the adafruit-Adafruit-ST7735-Library. From Arduino UI go to Sketch -

2020-05-25 05:38:34 Nuttig (0)
Verzenden
antwoorden (2)
MinimumRC F8F RareBear Pro 360 mm spanwijdte 4CH KT boord RC vliegtuig met 8520 kernloze motor KIT / PNP
US$12.99 US$25.99

Q: Can you give a link or part number of the battery for this plane? Thanks.

gevraagd door q500dude op 2019-05-28 05:56:29
Verzenden
antwoorden (0)
q500dude 17/09/2019
love having warm feet. I run it off a powerbank for portability.
5V 2A Elektrisch Verwarmde Voetinzool USB Voet Verwarmer Ademend Wasbaar en Bijgesneden Deodorant Met Adapter
US$15.99 US$19.99
0
aanbevelingen
Reacties (0)
q500dude 15/01/2019
Mine came with only 1 wire. The red one. Who cares, I can solder. Photo is still sealed bag. Would be good to understand usage of 2 vs 3 wire modes. I'm sure the internet knows the answer.
Geekcreit® 0,28 Inch 2,5V-30V Mini Digitale Voltmeter Spanningstester Twee-nummerige Voltmeter
US$6.29 US$8.99
0
aanbevelingen
Reacties (1)
0,95 inch 7-pins full-color 65K kleuren SSD1331 SPI OLED display
US$5.77 US$22.99

Q: The description says SPI but the pictures show I2C. Which one is it?

gevraagd door q500dude op 2018-06-06 06:02:01

Braggadocio It is SPI .

2018-06-14 01:28:37 Nuttig (0)
Verzenden
antwoorden (1)

Jij bent de expert, kan je helpen?

We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!

Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.

Help anderen en wees gelukkiger!

  • Abonneren

Over badges

Badges zijn gerelateerd aan de community en gebruikers verdienen badges door kwaliteitsinhoud te creëren, missies te voltooien of door deel te nemen aan speciale activiteiten. Specifieke mensen hebben ook hun eigen exclusieve badge.
CEO badge

de ceo-badge is alleen in handen van de baas van Banggood.

Badges die je kunt verdienen, komen binnenkort
  • Oké

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • Oké

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe