temporalflux
mijn inhoud
Alle berichten
Beoordelingen
Reacties
antwoorden
vragen

Alle berichten

temporalflux Thankyou for confirming that these fit the Aomway goggles. Your review was very helpful. They fit my Commander V1, perfectly.

RamNas 10/07/2022
Fits also the Aomway V1S! Good quality, thick foam that stays in place. I used the thick one for my Fatshark Attitude v6 and I put the thinner one on my Aomway V1S goggles. works great on both models.
2 stuks URUAV Universele opgewaardeerde dunne zachte spons pad reserveonderdeel voor HD3 HDO HDO2 Attitude V6 FatShark FPV-bril
US$12.49 US$29.99
3
Reacties (2)
4 Paren Gemfan 1636 1.6x3.6x4 40mm 4-blade 1mm Gat Propeller voor 1103 1105 RC Drone FPV Race Borstelloze Motor
US$9.99 US$11.99

Q: There are two versions of these propellers. The description says 1mm hole but, the photos show the 1.5mm hole version. Which is it?

gevraagd door temporalflux op 2019-01-19 09:12:49

Hazzarino 1mm. Fit very tight. I had to break them to remove them again from the motors. Even one motor was damaged in the process as I had to use pliers. Also, not very well balanced. More vibrations than the cheap standard props.

2019-10-03 10:30:44 Nuttig (1)
Verzenden
antwoorden (3)
FUS Spartan V3 99 mm wielbasis F411 F4 Vluchtcontroller AIO 20A ESC 3-4S Freestyle FPV Racing Drone PNP met 200mW VTX Runcam Nano 2 FPV-camera
US$119.99

Q: Take note that this is no longer the quad that Nick Burns reviewed. The motors are now *****KV (thank you to Banggood for finally updating the description). The new motors have a much lower Kv, which will quite substantially alter the performance of this quad, for better or worse.

gevraagd door temporalflux op 2020-10-16 03:39:24

Tritavus new 1106 3800KV motor flight in 4s is better than Old 1104 4500kv motor version. old 1104 4500kv motor fly in 3S more better than 4S.

2020-10-20 10:58:59 Nuttig (0)
Verzenden
antwoorden (1)
Fonster Kpro125 125 mm tandenstoker 2,5 / 3 inch 3 mm arm FPV Racing Frame Kit verstelbare camera
US$21.99 US$26.99

Q: What are the dimensions of the Motor mounting pattern? Descriptions says 9x12 thats pretty weird!

gevraagd door Polizyste op 2020-03-03 09:59:22

temporalflux It is a 9x9mm mounting pattern. Motors with a 12x12mm mounting pattern won't fit, even if you only use 2 screws.

2020-09-24 08:59:14 Nuttig (0)
Verzenden
antwoorden (2)
Eachine Mini Mustang P-51D Mini F4U T-28 Trojan Spitfire BF109 F16 F22 P40 RC Vliegtuig Reserveonderdeel φ10mm Hollow Cup Brushless Motor
US$6.00 US$15.59

Q: Why does it say brushless? It says it, not only in the title but also, in the decription. Is no-one going to fix this?

gevraagd door temporalflux op 2020-06-26 08:48:52

pappasggr Yes but you have to inspect such errors and correct them.... are unexpectable

2020-09-11 01:03:28 Nuttig (1)
Verzenden
antwoorden (1)
temporalflux 05/10/2018
Like the VTX03, the VTX03S performs amazingly well for such a small VTx. And now they have added SmartAudio as well! I only which they would stop putting those useless connectors on the cables, they don't fit anything anyway.
Eachine VTX03S 0/25/50/100/200mw 5.8Ghz 40CH Mini FPV zender ondersteunt PITmodus Smartaudio voor RC Drone
US$23.00 US$52.79
1
aanbevelingen
Reacties (1)
temporalflux 05/10/2018
These are not only a direct replacement for the servos in the XK X520 but, they also fit the Eachine E500 as well (although you do have to change the connector to a 1.0mm connector). The little plastic gears inside do shear easily so, get plenty of spares.
XK X520 2.4G 6CH FPV RC Vliegtuig Reserveonderdeel 4.3g Digitale Servo
US$12.99 US$15.59
1
aanbevelingen
Reacties (0)
Eachine TRASHCAN 75 mm Crazybee F4 PRO OSD 2S Whoop FPV Racing Drone Caddx Eos2 verstelbare camera 25 / 200mW VTX
US$115.00 US$135.99

Q: can i flash the recever with eu compatible firmware ?

gevraagd door DimitriDe Puysseleyr op 2018-12-02 01:52:41

temporalflux Extremely doubtful, as the receiver is built into the flight control board. However, you should be able to add an external receiver - an XM, for instance.

2018-12-02 07:25:42 Nuttig (0)
Verzenden
antwoorden (8)
Emax Tinyhawk Indoor FPV Racing Drone BNF RTF F4 4in1 3A 15000KV 37CH 25mW 600TVL VTX 1S
US$95.99 US$141.99

Q: i need a DSMX version

gevraagd door Vincent op 2018-11-02 10:29:58

temporalflux You can add an external DSMX receiver. Emax have never made a DSMX BNF (only FrSky) and, I doubt they will start now.

2018-11-03 07:33:35 Nuttig (0)
Verzenden
antwoorden (5)
temporalflux 05/10/2018
A 2.5mm bottom plate may be enough for the Y150 but, it certainly is not for the Y180. The arms have far too much flex. Not only that but the motor screw-holes are milled far too close to edge of the carbon. The stack mounting pattern is 30x30mm which is large for a quad this size, especially considering how little room that you have under the top-plate. It took me ages to find motors that would actually fit the mounting pattern. I eventually did get some iFlight iPower MT1806 2300Kv motors to fit. It flew great until the first soft landing bent and arm.Guess where it broke... yes,at that weak point where the screw-holes are milled too close to the edge of the carbon. I've had this frame for two days and, got about 3 flights out of it... pathetic.
Realacc Y150 Y180 Y200 150mm 180mm 200mm 4mm arm frame met carbon frame met PDB Board voor RC Drone FPV Racing
US$26.59 US$35.09
1
aanbevelingen
Reacties (1)
temporalflux 05/10/2018
What can I say? It is a RP-SMA extention cable. It is very short but it is ideal for taking the stress in a crash, which would otherwise be directly transferred to the VTx.
60 mm Lage verlies antenne verlengsnoer draad vaste basis voor antenne SMA RP-SMA RC Drone
US$6.99 US$8.39
0
aanbevelingen
Reacties (0)
temporalflux 05/10/2018
Good to have a spare frame because they do break easily with the relatively high 1S power of the UK65. Comes with all the relevant little screws, which is good because those can be hard to source.
Eachine UK65 65mm Whoop FPV Racing framekit & ABS camerakap
US$6.04 US$9.06
0
aanbevelingen
Reacties (0)
temporalflux 05/10/2018
This flight controller is well laid out and well labelled. The pads took solder very well, unlike most other budget boards. It has some really nice features, such as the current sensor, OSD built-in PDB. Excellent value. I recommend.
9g 30.5x30.5mm Omnibus F4 Vlucht Controller AIO OSD 5V BEC Stroomsensor voor RC FPV Racing Drone
US$31.99 US$38.99
0
aanbevelingen
Reacties (0)

Jij bent de expert, kan je helpen?

We nodigen je van harte uit om je te abonneren op de Invite Answer-e-mail!

Als u zich abonneert, nodigen we u uit via e-mail om vragen te beantwoorden die mensen hebben over producten. Door je te abonneren, verdien je ook de "Behulpzame Badge "! U kunt zich op elk moment uitschrijven op de pagina met privacyinstellingen.

Help anderen en wees gelukkiger!

  • Abonneren

Over badges

Badges zijn gerelateerd aan de community en gebruikers verdienen badges door kwaliteitsinhoud te creëren, missies te voltooien of door deel te nemen aan speciale activiteiten. Specifieke mensen hebben ook hun eigen exclusieve badge.
CEO badge

de ceo-badge is alleen in handen van de baas van Banggood.

Badges die je kunt verdienen, komen binnenkort
  • Oké

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • Oké

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe