Alle berichten

mszulen You mean an inrunner vs outrunner? The Inrunner (the case with Freewing) is easier to install. Check if your motor has threaded holes in the back (if yes - it's even easier to install). Otherwise you can use zip ties to the back of the motor (INRUNNER ONLY) via the cooling holes.

2023-09-12 10:07:45 Nuttig (0)
Verzenden
antwoorden (1)

mszulen Look at the balancer connector. It does not get the full 6s voltage. It's made to get 3s only from the connector. You could use it even on 10s :)

2023-09-12 10:02:24 Nuttig (0)
Verzenden
antwoorden (1)

Q: Hi, how many power does th battery have. I was just wondering.

gevraagd door BG141516153 op 2022-12-15 04:10:53

mszulen If you're asking about the battery capacity - it's 2s, 1000mAh

2022-12-15 04:23:45 Nuttig (0)
Verzenden
antwoorden (3)

Q: how much amperes esc for edf 40mm 8000kv merci

gevraagd door BG241522520 op 2022-05-12 10:09:08

mszulen 30A is enough

2022-05-16 03:22:03 Nuttig (0)
Verzenden
antwoorden (1)

Q: Does it come with 32 or 8 bit version of motherboard ?

gevraagd door BG421649144 op 2021-10-17 05:15:31

mszulen I've got 32bit 4.2.2 board (which I already swapped for SKR E3 Mini V2 :) )

2021-10-18 08:58:53 Nuttig (0)
Verzenden
antwoorden (7)

mszulen The rail i strong enough. On the other hand - check if you're not getting cured resin in the corners. This is known issue with this printer (light bleeding). It is NOT related to the build plate being warped. It's due to too high voltage set for the UV light. This can be set with the potentiometer in the power supply section.

2021-04-29 03:06:43 Nuttig (1)
Verzenden
antwoorden (7)

Q: What size ESC.

gevraagd door BG482436461 op 2020-10-16 08:06:04

mszulen 30A is more than enough

2020-10-17 11:15:50 Nuttig (0)
Verzenden
antwoorden (1)