mike_o
- mijn inhoud
- Alle berichten
- Beoordelingen
- Reacties
- antwoorden
- vragen
antwoorden
Q: looks like receiver module for fpv goggles. why title says it is transmitter for the drone?
gevraagd door doomystar op 2024-07-11 07:34:58
Q: Does it work with cuav pixhack v3?
gevraagd door jaimer op 2019-11-28 16:07:19
mike_o Yes, just set serial protocol to "10",
Nuttig (0)
mike_o 2-6S This one has the wide range SMPS
Nuttig (0)
Q: Do these work straight off 12V, or do they need some sort of voltage booster?
gevraagd door Hasi0 op 2020-01-25 12:52:01
mike_o Yes, they need a "ballast" unit, as they operate on 80-90V DC and an initial high voltage (kilovolt!) kick-start to get the ionisation going.
Nuttig (0)
mike_o Oh, you poor thing! 2 pcs are included in the deal.
Nuttig (0)
mike_o It's a brushed motor. A brushless motor will normally have 3 terminals, this one only has 2.
Nuttig (2)
mike_o I use a 2836mm (outside diameter) 1150KV motor with a Graupner 8x5 Eprop on 3S. I get below 100mAh/km which corresponds to 75mAh/km at 4S. Still plenty of thrust for launch and climb.
Nuttig (4)
Q: hi, the material of this plane is compatible with cyanoacrilate glue?
gevraagd door hendrick op 2019-08-18 15:56:09
mike_o Yes, the EPO is OK with CA glue. Actually, CA is the best for EPO, many established manufacturers recommend using CA for assembly.
Nuttig (1)
mike_o I agree that it looks like a Rx module for goggles. But why the heatsink, then? And why would the goggles need a video transmitter?
Nuttig (1)