Klantbeoordelingen

Schrijf een beoordeling
  • Alle beoordelingen(28)
  • Afbeeldingen
  • Videos
  • Ster
    • Ster(28)
    • 5 Star(25)
    • 4 Star(3)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sorteren op:
Top recensie
  • Top recensie
  • Meest nuttig
  • meest recent
Recensies alleen uit uw land (United States)
|
Toon origineel

Een deel van de recensie is automatisch vertaald.

  • 12/10/2020

    works nice. Build 2 PCBs in a Power Case with 30 HG2 Batteries with 90Ah nominal capacity total.

    Reacties (1)
    Toon origineel
  • 19/03/2021

    although it arrived fast ,in an unsafe package, it did not even have a protective bubble, nevertheless it works as intended.

    Reacties
    Toon origineel
  • 23/04/2021

    Very very poor packaging, just a plastic bag, no foam or bobble wrap, result = bend display see pictures, module is working.

    Reacties
    Toon origineel
  • 26/01/2021

    as expected, gut the percentate Display ist Bent a Bit.

    Reacties (1)
    Toon origineel
  • 27/03/2021

    all ok

    Reacties (1)
    Toon origineel
  • 10/09/2020

    thanks

    Reacties
    Toon origineel
  • 24/05/2021

    I am going to answer my own question about ports etc. I realise that I couldn't see the specification sheet on a mobile device - OK on a laptop. I did some experiments. The unit takes approx 50 microamps from the battery when off. When the battery is first connected , the unit takes approx 48mA and the two large USB sockets turn on producing around 4.94V. With no load they turn off again after some seconds, back to standby current. Pressing the button on the side, switches the unit on again, and it turns off some seconds later with no load. With a load it stays on. Charging can be via the micro USB, lightning connector or USB-C. The output of the unit goes from 4.94 to 4.87V when charging., and the unit digit of the display flashes to show charging. The display shows the percentage charge in the battery, although I didn't see numbers in the spec sheet for that. There is a problem using it as a no-break supply, because disconnecting the charging supply causes a momentary break in the output. I have discovered that before with other battery packs. Reconnecting the charging supply does not cause a break. I may experiment to see if a capacitor on the USB 5V out would hold up the supply as the input turns off - that would make it much more useful.

    Reacties (2)
    Toon origineel
  • 01/09/2021

    Very nice product! Work fine as discribe on product details. I had a power bank 20000Ah that had problem with controller. I replaced with this one and just new again. Works perfectly! I saved my power bank!

    Reacties
    Toon origineel
  • 09/08/2021

    Its and USB-C powersource from a single Liion/Lipo cell. It has four outputs-micro-USB, USB-C and two standart USBs with up to 3Amps output. Great for DIY powerbanks. Works fine.

    Reacties
    Toon origineel
  • 27/10/2020

    Works great with any type of 3,7V battery

    Reacties (1)
    Toon origineel
Show:

    Totaal 0 Pagina's

    Ga naar pagina

    Wellicht ben je ook geïnteresseerd in

    recommendation for you
    • US$5.69
    • US$5.56
    • US$8.99
    • US$5.99
    • US$9.99
    • US$2.99
    • US$9.99
    • US$5.39
    • US$26.99
    • US$13.99