TWO TREES® TOTEM S 40W-Lasergraveermachine Frame Kit Lasergraveerder Compressed Spot LD+FAC 5W 5,5W Snelle hoogprecieze printer laser cutter voor metaal hout roestvrij staal Beoordelingen

TWO TREES® TOTEM S 40W-Lasergraveermachine Frame Kit Lasergraveerder Compressed Spot LD+FAC 5W 5,5W Snelle hoogprecieze printer laser cutter voor metaal hout roestvrij staal

US$199.99

Nu kopen

Klantbeoordelingen

4.83 van5

Bekijk alle beoordelingen van29

5 ster
27 (93.1%)
4 ster
1 (3.4%)
3 ster
0 (0%)
2 ster
0 (0%)
1 ster
1 (3.4%)

Schrijf een beoordeling Ontvang dubbele banggoodpunten als je één van de 3 eerste beoordelingen plaatst!

Alle beoordelingen(29)
Afbeeldingen
Videos
Ster
- Ster(29)
- 5 Ster(27)
- 4 Ster(1)
- 3 Ster(0)
- 2 Ster(0)
- 1 Ster(1)

Sorteren op:

Top recensie

Top recensie
Meest nuttig
meest recent

Recensies alleen uit uw land (United States)

Toon origineel

Een deel van de recensie is automatisch vertaald.

ricbragVIP3
US
20/04/2022

A little bit trickier to assemble (the instructions are not very clear) but after a few attempts I finally figure it out. This YouTube video could help (https://youtu.be/8YIPKHZnk5w) it is not the same model, but the assembly is the same. The product works perfectly. Not sure if it has a true 5500 mW output. I was able to engrave some cardboard using a single pass with 30% power at 1000 mm/s speed, but it took 4 passes to cut a 1.5mm thick post-it pad using 100% power and 1000 mm/s speed. The cut was very sharp.

A little bit trickier to assemble (the instructions are not very clear) but after a few attempts I finally figure it out. This YouTube video could help (https://youtu.be/8YIPKHZnk5w) it is not the same model, but the assembly is the same. The product works perfectly. Not sure if it has a true 5500 mW output. I was able to engrave some cardboard using a single pass with 30% power at 1000 mm/s speed, but it took 4 passes to cut a 1.5mm thick post-it pad using 100% power and 1000 mm/s speed. The cut was very sharp.

A little bit trickier to assemble (the instructions are not very clear) but after a few attempts I finally figure it out. This YouTube video could help (https://youtu.be/8YIPKHZnk5w) it is not the same model, but the assembly is the same. The product works perfectly. Not sure if it has a true 5500 mW output. I was able to engrave some cardboard using a single pass with 30% power at 1000 mm/s speed, but it took 4 passes to cut a 1.5mm thick post-it pad using 100% power and 1000 mm/s speed. The cut was very sharp.
4

Reacties

Toon origineel
crleufrasio
PT
03/05/2022

Amazing

Amazing

Amazing
0

Reacties

Toon origineel