NZ Mini GPS Voor NAZE32 Flip32 6dof 10dof Beste Voor QAV250 ZMR250 RC Drone FPV Racing Multi Rotor
Een deel van de recensie is automatisch vertaald.
Works right out of the box. Just connect it to NAZE32 +5v, GND, Pin3 and Pin4. In Cleanflight enable UART2 port for GPS with 9400baud, than in Cleanflight configuration GPS enable, NEMA, en the you correct magnetic declination. You can find it on: http://www.magnetic-declination.com/
At first it worked ok, although it only found a maximum of 7 satellites. However, after a few minutes it became very hot and the number of satellites dropped to just 2-3. I repeated this a few times, just to confirm that the heat and the number of satellites was related, and then the module seemed to die completely. I opened it up and as you can see from my photos, the regulator has burnt out. There was a LOT of hot glue used in the construction and not much space inside. It looks like the regulator had been pressing on the inside of the RF shield case. The u-blox chip used is a good one, but I think it is let down by the too compact construction. In general, GPS modules don't need to be this small, and we don't usually have them on a small racing drone. Mostly they are used on larger aircraft, so we don't worry about the size so much but we want them to be reliable. I would like to see a module like this with the convenient connector, but using the normal size antenna, and with no hot-glue in the construction.