Inav F3 Deluxe 30.5x30.5mm Flight Controller geïntegreerd met M8N GPS Compass Baro OSD voor RC Drone
Een deel van de recensie is automatisch vertaald.
Everything works as advertised however the modification implemented for the I2C compass interface is very poorly done. This modification blocks the use of the rest of the pins on the connector. Had the wires simply been soldered on facing the opposite direction this could have been minimised. A more practical solution would have been to solder the pin header in place and the connect the pull up resistors to these pins allowing standard dupont connectors to be used.
Soldering needed, and would like a much more indepth manual
I can't seem to save my settings, it says to upgrade the firmware. But what board do i choose from the list? Thank you :)
good combo works fine but be carefull with usb port seem to be fragile
as expected
All OK!!!
I'm pretty new to the hobby and still learning haven't flown with this fc as yet but it seems to be doing the right things on the iNav configurator so I am happy enough as that goes. The big let down for me is the way the gps wires are soldered on making it hard to utilise the other connection points. I am a bit nervous to try and move them as there are 2 tiny components adjoining the orange and dark blue wires. I'm not sure what to do...
bon produit , mise à par le port USB qui ne tiens vraiment pas
Is there anyone who can help with the updating of the firmware. cant do anything. Do not know what firmware to choose from the drop down list. Please help. I can not do anything.
Antenne GPS soudé sur FC donc impossible de soudé un connecteur. carte pas encore testé.