Geeetech® RAMPS-FD Controller moederbord voor due reprap 3D-printer
Een deel van de recensie is automatisch vertaald.
Pour upgrader une reprap
Well received, is already werking.
Overall there is nothing wrong with the board that I can tell, but upon delivery the bag had a severe snag, and when opened the board had massive amounts of pins that were bent. I have never had a problem before with any order, and believe this is a one time event. I still have not been able to connect this in circuit, but have no doubt it will work.
ok
Devo ancora montarla e fare il collaudo.
Picture shows jumpers, didn't get any, lucky I have spares. Does okay would like v2 but not avaliable
if you use this know you have to check your outputs. it is working great but the V1 has some problems. but there are workarounds. and is now working for my needs
Good deal
Everything is fine and fast
Great 32 bit controller for your printer. I am using it for just pla with no heater bed. Because online they say don't use a heater bed with this board.