GANWEI Cantilever Tapping Tool CNC Aluminium Legering Geanodiseerde Afwerking 1.5-10mm Chuck Professionele Tappenondersteuning Stabiele Bevestiging Beoordelingen

GANWEI Cantilever Tapping Tool CNC Aluminium Legering Geanodiseerde Afwerking 1.5-10mm Chuck Professionele Tappenondersteuning Stabiele Bevestiging

US$59.99
~~US$70.99~~
Nu kopen

Klantbeoordelingen

5 van5

Bekijk alle beoordelingen van3

Schrijf een beoordeling Ontvang dubbele banggoodpunten als je één van de 3 eerste beoordelingen plaatst!

Alle beoordelingen(3)
Afbeeldingen
Videos
Ster
- Ster(3)
- 5 Ster(3)
- 4 Ster(0)
- 3 Ster(0)
- 2 Ster(0)
- 1 Ster(0)

Sorteren op:

Top recensie

Top recensie
Meest nuttig
meest recent

Recensies alleen uit uw land (United States)

Toon origineel

Een deel van de recensie is automatisch vertaald.

KiranVIP5
IN
17/07/2026

This stand is almost perfect for cutting threads with a drill tap bit. It has some play around the elbow and isn't precise enough for drilling, but this is an advantage for tapping as it self-aligns. I wish the shank was a standard 6.35mm hex size so I could put it directly into an impact driver. For now I use a socket driver bit, which increases the height and causes a bit more wobble. The included clamp works for drilling downwards but not sideways. Long workpieces like aluminium extrusions are easier to clamp to a table-top than to suspend over the edge with perfect alignment, so a 90° clamp will be a great improvement. This is a non-issue if the table has a square leg near the edge, but none of my workshop tables are like that.

This stand is almost perfect for cutting threads with a drill tap bit. It has some play around the elbow and isn't precise enough for drilling, but this is an advantage for tapping as it self-aligns. I wish the shank was a standard 6.35mm hex size so I could put it directly into an impact driver. For now I use a socket driver bit, which increases the height and causes a bit more wobble. The included clamp works for drilling downwards but not sideways. Long workpieces like aluminium extrusions are easier to clamp to a table-top than to suspend over the edge with perfect alignment, so a 90° clamp will be a great improvement. This is a non-issue if the table has a square leg near the edge, but none of my workshop tables are like that.

This stand is almost perfect for cutting threads with a drill tap bit. It has some play around the elbow and isn't precise enough for drilling, but this is an advantage for tapping as it self-aligns. I wish the shank was a standard 6.35mm hex size so I could put it directly into an impact driver. For now I use a socket driver bit, which increases the height and causes a bit more wobble. The included clamp works for drilling downwards but not sideways. Long workpieces like aluminium extrusions are easier to clamp to a table-top than to suspend over the edge with perfect alignment, so a 90° clamp will be a great improvement. This is a non-issue if the table has a square leg near the edge, but none of my workshop tables are like that.
0

Reacties

Toon origineel
Afcona
IN
15/04/2026

best quality and good design ,highly recommended

best quality and good design ,highly recommended

best quality and good design ,highly recommended
0

Reacties

Toon origineel