Klantbeoordelingen

Schrijf een beoordeling
  • Alle beoordelingen(44)
  • Afbeeldingen
  • Videos
  • Ster
    • Ster(44)
    • 5 Ster(38)
    • 4 Ster(6)
    • 3 Ster(0)
    • 2 Ster(0)
    • 1 Ster(0)
Sorteren op:
Top recensie
  • Top recensie
  • Meest nuttig
  • meest recent
Recensies alleen uit uw land (United States)
|
Toon origineel

Een deel van de recensie is automatisch vertaald.

  • 08/10/2021

    good quality

    Reacties
    Toon origineel
  • 08/10/2021

    very good

    Reacties
    Toon origineel
  • 22/07/2020

    I feel this gauge provides good value for cost. Of course it contains some plastic but the magnetic base works well. The probe/scriber is held by 2 small screws & it would be nice if it were easier to substitute different probes for some measuring situations. However the very reasonable price put this gauge well within the budget of many home machinists. No regrets.

    Reacties
    Toon origineel
  • 07/11/2019

    The item looks and feels good, quality made. But... It's plastic with all ensuing consequences - it flexes. Not a lot, but flexes. Still, it's better then doing your layout with a ruler. It could be cheaper, though. If a metal caliper can be had for about $12, what's so special about this thing to cost almost whole $20?!

    Reacties
    Toon origineel
  • 03/02/2020

    The foot is plastic containing 4 magnets. Using it on a granite table, the leight weight calls for one hand holding it down firmly. Accurazy is good. I'll probable take it apart and make a lead weight to put inside. The angle of head guide is a bit less than 90 degrees causing a "cosine error". A budget buy, good for hobbyists.

    Reacties
    Toon origineel
  • 21/12/2020

    Good value for money, magnetic base is quite powerful, perfect for setting table saw blade Hight. With a resolution of 0.01 mm adequate for marking out, setting tool centre hight on lathe. Pleased with purchase

    Reacties
    Toon origineel
  • 11/12/2020

    Nice value for money height gauge. Quite light as it's made from plastic rather than steel but if care is taken is more than accurate enough for marking out. Base could probably benefit from some more weight but also has magnets to help on metal surfaces.

    Reacties
    Toon origineel
  • 18/08/2020

    Looks to be ok. No battery so haven't been able to test yet. Battery should be included, even in a separate package. BG should advertise battery available with the items needing them. RonW

    Reacties
    Toon origineel
  • 14/08/2020

    Not impressed whit this buy. Very flimsy, flexes too easely from side to side due to plastic construction. Repeatedly precise measurements are difficult to acheave even with the magnetic base but for wodworking I guess it's OK.

    Reacties
    Toon origineel
  • 25/07/2020

    Einfache, leicht Ausführung. Bei meinem Display ist keine Bruchanzeige zu sehen. Die Einstellung springt nur zwischen "mm" und "inch" Ich habe die Ausführung für die Batterie CR2032 bekommen.

    Reacties
    Toon origineel
Show:

    Totaal 0 Pagina's

    Ga naar pagina

    Wellicht ben je ook geïnteresseerd in

    recommendation for you
    • US$52.99
    • US$5.99
    • US$15.99
    • US$8.99
    • US$9.99
    • US$11.99
    • US$29.99
    • US$15.99
    • US$18.99
    • US$17.99
    • US$17.99
    • US$59.99
    • US$24.99
    • US$62.99
    • US$7.99
    • US$62.99
    • US$12.99
    • US$13.99