I'm using it on my DJI v1 FPV goggles with a 50cm trainer (mono audio) cable connected to my Jumper T-Lite, Taranis X9D, or TX16S handset. The open source software used to configure it is feature rich and allows configuring many details. When mounting it to the DJI v1 goggles, there is about 3mm gap between the right side of the board (looking at the photo) and the goggles. That makes the board vulnerable to damage if bumped since it's only screwed down on the left side. My solution to that was to fill the gap with some nano tape. The reset button is extremely small and difficult to find by feeling for it when flying, so to solve that, I bought a low profile momentary switch from ali express (search for "4 Pcs Momentary Switch Momentary Push Button ON Off Switch 12V 24V Surface Mount Mini Button Switch") and soldered that to the appropriate pads on the board. I noticed only 1 issue that could be a hardware issue: The configured channel output range varies depending on whether the board is being powered by USB or not. I've posted a bug report about that to the github dlktdr/HeadTracker page.

I'm using it on my DJI v1 FPV goggles with a 50cm trainer (mono audio) cable connected to my Jumper T-Lite, Taranis X9D, or TX16S handset. The open source software used to configure it is feature rich and allows configuring many details. When mounting it to the DJI v1 goggles, there is about 3mm gap between the right side of the board (looking at the photo) and the goggles. That makes the board vulnerable to damage if bumped since it's only screwed down on the left side. My solution to that was to fill the gap with some nano tape. The reset button is extremely small and difficult to find by feeling for it when flying, so to solve that, I bought a low profile momentary switch from ali express (search for "4 Pcs Momentary Switch Momentary Push Button ON Off Switch 12V 24V Surface Mount Mini Button Switch") and soldered that to the appropriate pads on the board. I noticed only 1 issue that could be a hardware issue: The configured channel output range varies depending on whether the board is being powered by USB or not. I've posted a bug report about that to the github dlktdr/HeadTracker page.

I'm using it on my DJI v1 FPV goggles with a 50cm trainer (mono audio) cable connected to my Jumper T-Lite, Taranis X9D, or TX16S handset. The open source software used to configure it is feature rich and allows configuring many details. When mounting it to the DJI v1 goggles, there is about 3mm gap between the right side of the board (looking at the photo) and the goggles. That makes the board vulnerable to damage if bumped since it's only screwed down on the left side. My solution to that was to fill the gap with some nano tape. The reset button is extremely small and difficult to find by feeling for it when flying, so to solve that, I bought a low profile momentary switch from ali express (search for "4 Pcs Momentary Switch Momentary Push Button ON Off Switch 12V 24V Surface Mount Mini Button Switch") and soldered that to the appropriate pads on the board. I noticed only 1 issue that could be a hardware issue: The configured channel output range varies depending on whether the board is being powered by USB or not. I've posted a bug report about that to the github dlktdr/HeadTracker page.

Good recieved in good condition and fast delivery

Good recieved in good condition and fast delivery

Good recieved in good condition and fast delivery

nice!

nice!

nice!

works as advertised. However, I still experience drift and I don't know why

works as advertised. However, I still experience drift and I don't know why

works as advertised. However, I still experience drift and I don't know why