Very good. It works correctly with other whether stations.

Very good. It works correctly with other whether stations.

Very good. It works correctly with other whether stations.

uses standard digoo protocol. channel switch is not present but you can switch channels by installing a switch or shorting pins on the board. sends channel 0 by default. poorly soldered antenna

uses standard digoo protocol. channel switch is not present but you can switch channels by installing a switch or shorting pins on the board. sends channel 0 by default. poorly soldered antenna

uses standard digoo protocol. channel switch is not present but you can switch channels by installing a switch or shorting pins on the board. sends channel 0 by default. poorly soldered antenna

zásielka v poriadku ale nefunguje s mojou meteostanicou nakoľko mi poslali iný vid foto.

zásielka v poriadku ale nefunguje s mojou meteostanicou nakoľko mi poslali iný vid foto.

zásielka v poriadku ale nefunguje s mojou meteostanicou nakoľko mi poslali iný vid foto.

Very good sensor. Works well with RTL_433 (reports as a "Nexus-TH"). There is no switch to select the channel but the PCB has holes for one so you can either add a switch or hard-wire it. This will void the guarantee so only try this if you know what you're doing. It isn't really necessary to add a channel option since the sensor also sends another code (reported by RTL_433 as "House Code") which can be used to identify it from the others on the same channel. I pipe the output to MQTT & Node-RED and it works perfectly.

Very good sensor. Works well with RTL_433 (reports as a "Nexus-TH"). There is no switch to select the channel but the PCB has holes for one so you can either add a switch or hard-wire it. This will void the guarantee so only try this if you know what you're doing. It isn't really necessary to add a channel option since the sensor also sends another code (reported by RTL_433 as "House Code") which can be used to identify it from the others on the same channel. I pipe the output to MQTT & Node-RED and it works perfectly.

Very good sensor. Works well with RTL_433 (reports as a "Nexus-TH"). There is no switch to select the channel but the PCB has holes for one so you can either add a switch or hard-wire it. This will void the guarantee so only try this if you know what you're doing. It isn't really necessary to add a channel option since the sensor also sends another code (reported by RTL_433 as "House Code") which can be used to identify it from the others on the same channel. I pipe the output to MQTT & Node-RED and it works perfectly.

товар не соответствует описанию он не подходит

товар не соответствует описанию он не подходит

товар не соответствует описанию он не подходит

it works fine. recommended

it works fine. recommended

it works fine. recommended

Датчик заказывал под метеостанцию с такой же частотой, всё подошло.

Датчик заказывал под метеостанцию с такой же частотой, всё подошло.

Датчик заказывал под метеостанцию с такой же частотой, всё подошло.

доставка быстрая ок

доставка быстрая ок

доставка быстрая ок

BEST

BEST

BEST

works well

works well

works well